Part Number: DS90UB953-Q1 Other Parts Discussed in Thread: ALP
Team,
In order to do some system level testing between 953 -> cable -> 954 how can the BIST capability (mentioned in DS section 7.3.4.4 Built-In Self Test) be used? Do you have a script…
Part Number: DS90UB953-Q1 I have a one lane sensor connected to serializer ub953. sensor device is detected and probed successfully. Even I was able to capture frames from it a few days back.
but when I tried again recently with same setup, same driver…
Part Number: DS90UB953-Q1 Hi team,
I have a question.
If our module uses 953 serdes, it is used in four AVM camera modules. The four camera modules need to be synchronized. In addition to the frame sync pin of the sensor being connected to the 953 GPIO…
Part Number: DS90UB953-Q1 Other Parts Discussed in Thread: DS90UB954-Q1 Hello,
My customer has developed a camera module with onsemi sensor and TI953.
The PN of TI953 used by my customer is DS90UB953TRHBRQ1.
My customer is trying to connect this module…
Hi Itay,
Understood, just wanted to clarify it was not in the config file. Since error clearing is being done intermittently, I don't think this would be the source of the issue.
Since components can not be replaced, my suggestion would be to test…
Part Number: DS90UB953-Q1 Other Parts Discussed in Thread: ALP , DS90UB954-Q1 , DS90UB954-Q1EVM , TDA4VM Hello all,
I'm looking for a solution with evaluation board or development kit to perfom the initial operation and testing of a camera with DS90UB953…
Part Number: DS90UB953-Q1EVM Hi,
From lots of the discussion in the forum, the parallel resistor on POC circuit's inductor is mainly to not make the impedance so high when the frequency is close to the SRF of the inductor. But I don't quite understand…
Part Number: DS90UB953-Q1 Hi sir/mam,
I am using your component DS90UB953-Q1 in our design and extracted some eye diagrams of MIPI signals .
can you please provide us the eye standards for my validation.
So that i can compare my results with the stan…
Part Number: DS90UB953-Q1 Hello.
We are using the component : DS90UB953-Q1 in our design .
So i am looking for the FPDIII & Csi Eye diagrams and Eye Mask receiver standard details for signal integrity.
Regards.
Raneel.
Part Number: DS90UB953-Q1 Other Parts Discussed in Thread: DS90UB9702-Q1 , Hello TI,
I want to migrate from (DS90UB935) to DS90UB953-Q1 using same Deserializer DS90UB9702-Q1 so my question what configuration I should change to migrate.