Part Number: DS90UB960-Q1EVM Tool/software: i want to connect and HDMI capture card to this DS90UB960-Q1EVM board Can i use a MIPI-to-HDMI bridge to connect my HDMI capture card to it ? (link to bridge: www.digikey.ca/.../7623050
Part Number: DS90UB960-Q1EVM
Tool/software:
Hello, is it possible to connect DS90UB960-Q1EVM board to the reComputer J30. The board has 2 MIPI CSI Outputs. The J30 reComputer contains MIPI-CSI connector which is 22 pin. Is there a wire that can be…
Part Number: DS90UB960-Q1EVM Other Parts Discussed in Thread: DS90UB960-Q1 , Tool/software: Hello TI expert,
We are planning to use the deserializer DS90UB960-Q1 in our VW LVDS ECU project.
Could you please help to share the design files of DS90UB960…
Part Number: DS90UB960-Q1EVM
Enviroment : currently, we are using an FPGA to simulate a camera. The system is TDA4 -> Dser 960 -> Ser 971 -> FPGA like picture above - SER971 use this mode : Synchronous FPD-Link III / 50 Mbps BC Rate - DSER960 : Internal…
Part Number: DS90UB960-Q1EVM Tool/software: Hi We have few questions about the 960 EVM, which could not get resolved after reading the user manual.
Requesting inputs on the below.
1. Is the J30 power cable or J26 power cable included in the EVM…
Part Number: DS90UB960-Q1EVM Tool/software: Hi,
I want to interface the MIPI-CSI2 input from the nvidia ORIN kit with the TI's EVM. As the ORIN platform do not have the Fakra in and only has the MIPI-CSI2 in.
So, would like to know if the MIPI CSI2…
Part Number: DS90UB960-Q1EVM Other Parts Discussed in Thread: TSER953 Tool/software: Hi Team, we have DS90UB960-Q1EVM. I can able to run the link margin using analog launch pad. Attached test results. Test case: Deser: TDES960RTDT Ser: TSER953 Cable length…
Part Number: DS90UB960-Q1EVM Hello: I try to light on the 0X01F camera in our evm board. right now the SOC can not recongnize the MIPI CSI signal. can you help to analysis the problem. thx and here is the light on register setting for 953&960:
i2ctransfer…
