Part Number: DS90UB962-Q1 Hi,
Currently, I am using Ti962 deserializer for streaming four same kind of sensors with (1620W x 1284H) and 30fps by using virtual channel concept. It's able to streaming but the frame rate is degrading.
Here I have configured…
Part Number: DS90UB962-Q1 Hi Expert,
Our customer want to re-use platform design. Currently they use 962 + 935 in MP. Now they would like to use 962 + 933 for a new project. But they cannot change 962 hardware design and software design dur to time limit…
Part Number: DS90UB962-Q1 Hi team,
Is there a requirement for eye height in CML output eye pattern in DS90UB962-Q1?
I can only see eye width in the datasheet as below.
regards,
Part Number: DS90UB935-Q1 Other Parts Discussed in Thread: DS90UB962-Q1 , Hello:
The professional flat panel project has four cameras. The four cameras use TI chips ds90ub935-q1 and ds90ub962-q1
Now the Ti chips need to write registers, and customer wants…
Part Number: DS90UB962-Q1 Hi,
From datasheet, the FPD3_MODE 00 represented for 2 status: reserved or CSI-2 mode
it's confusing.
and when customer want to change 964 to 962, what should be paid attention to?
do we have detailed comparison for 960…
Part Number: DS90UB962-Q1 Other Parts Discussed in Thread: ALP , USB2ANY Dear TI team,
We find that it sometimes gets incomplete frames while previewing cameras. Then we follow 7.5.10 Error Handling and set PORT_CONFIG2 and PORT_PASS_CTL . This is our…
Part Number: DS90UB962-Q1 The 962 datasheet groups all the 1V8 supply pins into a single spec. Can you please provide what percentage of the total current each bank (VDD18_Px, VDD18_FPDx, VDD18A) is consuming?
Part Number: DS90UB962-Q1 Hello,
There is a mention on the first page of the datasheet.
• Supports 1-Megapixel Sensors With HD 720p/800p/960p/1MP Resolution at 30-Hz or 60- Hz Frame Rate
Is it means that unsupport lower than 720p r esolution?
…
Part Number: DS90UB962-Q1 What are the load characteristics of the REFCLK (pin 5)? I need to provide this to the oscillator supplier so that I can ensure we meet the TI rise/fall time requirements.