TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel


Search tips
Showing 37 results View by: Thread Post Sort by
    Answered
  • DS92LV2411/DS92LV2412 PLL UNLOCK time

    toshi-e2e
    toshi-e2e
    Resolved
    Other Parts Discussed in Thread: DS92LV2412 , DS92LV2411 Hi! all, What is the PLL UNLOCK time of both DS92LV2411 and DS92LV2412? Regards, Toshi
    • Resolved
    • over 10 years ago
    • Interface
    • Interface forum
  • RE: DS92LV2412 Datasheet revision errors?

    Nasser Mohammadi
    Nasser Mohammadi
    Hi Eric, You are correct it was an error to say the pin could be grounded. DS92LV2412 and DS90UR906 use the IP but different ratings. You can also refer to the DS90UR906 data sheet. Do you happen to have a logic analyzer? Perhaps you can take a look…
    • over 12 years ago
    • Interface
    • Interface forum
  • DS92LV2412 lock drop out

    John Merrill
    John Merrill
    Other Parts Discussed in Thread: DS92LV2412 My DS92LV2412 is on a pcb to which a flex circuit from my LCD is attached. When I test the output signals with the lcd detached all signals look normal (clk is 10.6MHz and LOCK is a steady High). When I attach…
    • over 12 years ago
    • Interface
    • Interface forum
  • Answered
  • RE: DS92LV2411 to DS92LV2412 communication issue

    Nasser Mohammadi
    Nasser Mohammadi
    Resolved
    Hi John, First of all, to answer your question, if straps were pulled high on a power up once this should not damage the device. In any case to make sure the problem you are seeing is not a general issue vs a board stuffing issue please confirm this…
    • over 13 years ago
    • Interface
    • Interface forum
  • RE: DS92LV2412 Lock drop due to power supply noise

    Mike Wolfe
    Mike Wolfe
    Hi John, Power design issues could be an issue, but pattern dependant issues usually point to signal integrity problems on the parrallel bus for these parts. Can you probe the input signals on the serializer? Please check that the signals do not…
    • over 11 years ago
    • Interface
    • Interface forum
  • DS92LV2412 testing

    John Merrill
    John Merrill
    Other Parts Discussed in Thread: DS92LV2412 , DS92LV2411 I need to test my DS92LV2412 circuit at my PCBA CM. I want to perform a simple test to ensure that the device is working. What i want to do is use my data acquisition hardware to drive the pins…
    • over 13 years ago
    • Interface
    • Interface forum
  • Issue with DS92LV2412 clock recovery below 10Mhz

    Charles H
    Charles H
    Other Parts Discussed in Thread: DS92LV2412 , DS92LV2411 , AM3703 The issue I found was that the LOCK signal being asserted indicating a loss of clock recovery at the DS92LV2412 deserializer. This occurred with the pixel clock set to 10MHz. When I increase…
    • over 13 years ago
    • Interface
    • Interface forum
  • IBIS Model DS92LV2411 and DS92LV2412

    Johann Amstutz
    Johann Amstutz
    Other Parts Discussed in Thread: DS92LV2412 , DS92LV2411 , DS92LV2421 , DS92LV2422 Hello I've downloaded the IBIS Models of the serializer DS92LV2411 and the deserializer DS92LV2412. We found out that the the serial input / output ports are not connected…
    • over 12 years ago
    • Interface
    • Interface forum
  • Deserializer for multidrop STP Cable ~1Gbit/s (DS92LV2412 possible?)

    Tobias P
    Tobias P
    Other Parts Discussed in Thread: DS92LV2412 , DS32ELX0421 , DS32ELX0124 , DS30EA101 , DS100MB201 Hi, Is there any deserializers that can be used in a multidrop configuration ? Configuration: Data source (FPGA) ~800Mbit-1300Mbit/s The same signal will…
    • over 12 years ago
    • Interface
    • Interface forum
  • DS92LV2411, DS92LV2412 24-bit channel link II serializer and deserializer

    John Merrill
    John Merrill
    Other Parts Discussed in Thread: DS92LV2412 , DS92LV2411 Hi All, I have a serdes pair consisting of a DS92LV2411 serializer and a DS92LV2412 deserializer. The below pic demonstrates the suggested electrical connections from TI. My questions has to…
    • over 13 years ago
    • Interface
    • Interface forum
<>

Didn't find what you are looking for? Post a new question.

  • Ask a new question