Other Parts Discussed in Thread: ENERGYTRACE , LP-CC2652R7 Hi
I am trying to run EnergyTrace in standalone mode. Unfortunately, EnergyTrace only runs when the debugger is running. I just get this window if I start EnergyTrace without starting the debugger…
Part Number: CC1350STK Other Parts Discussed in Thread: ENERGYTRACE , , CC1350 Hello,
I have a CC1350STK sensor tag. I want to do an Energytrace analysis on them to figure out their current consumption. Can you let me know how can I do it? I tried to use…
Part Number: ENERGYTRACE Hi
Be Energy Trace Support MSP430FG6xx device?
I can not find in "supported products" in Energy Trace page.
But I think MSP430FG6xx series is same userguids to MSP430F6xx.
However I can find MSP430F6xx in "supported products…
Part Number: LP-CC2652R7 Other Parts Discussed in Thread: ENERGYTRACE Hi,
I want to use two Launchpads in parallel. If i try to start a current measurement in CLI with stune the measurement will be interrupted and I got the message "BAD DATA detected"…
Part Number: LAUNCHXL-CC26X2R1 Other Parts Discussed in Thread: ENERGYTRACE Hello,
I'm using the LAUNCHXL-CC26x2R1 and want to use Energy Trace via command line tool stune. I already able to measure currents. Now I have one question is it also possible…
Part Number: LAUNCHXL-CC26X2R1 Other Parts Discussed in Thread: ENERGYTRACE Hello,
I'm using the LAUNCHXL-CC26x2R1 and want to use Energy Trace in CCS. The default supply voltage is 3.3V. But I want to change this to 1.8V. I have found several locations…
Part Number: LAUNCHXL-CC26X2R1 Other Parts Discussed in Thread: ENERGYTRACE Hello,
is it possible to use XDS110 as command line for current measurement?
Part Number: CC2652R7 Other Parts Discussed in Thread: ENERGYTRACE
Good day, I am using the CC2652R7 launchpad, and I have a function defined below called "configureSED()" that sets the data poll period for a sleepy end device to every 10 seconds.…
Part Number: LP-XDS110ET Other Parts Discussed in Thread: ENERGYTRACE I have an XDS110ET and I want to use energytrace just as a current sensor for an ESP32 board (powering ESP32 board off the 3.3V output pin on the XDS110ET 20P connector)
Is this doable…
Other Parts Discussed in Thread: ENERGYTRACE When I start EnergyTrace in CCS 12.2.0.00009 , it only show the following dialog box and not start EnergyTrace actually. What can I do to fix this issue?