Hi Jerome,
Jerome Beguin said: I still have a question. How are we suppose to setup the pull-up / pull-down resistor on the GPIOs.
Because some of them are also used for DSI configuration at boot. So should I keep the config for DSI lines or set up…
Part Number: TMS320F28388D Other Parts Discussed in Thread: TMDSCNCD28388D , TMDSHSECDOCK , TMDSFSIADAPEVM
Hi
My customer are thinking to evaluate with TMDSCNCD28388D +TMDSHSECDOCK +TMDSFSIADAPEVM.
To supply the power to each EVMs, they are…
Hi Minhyeong,
Thank you for posting to the Sensors forum!
If you are looking for a smaller EVM to evaluate the DRV5056, one option that you can do is get the HALL-ADAPTER-EVM . The HALL-ADAPTER-EVM is a breakout board that has a bunch of different…
Part Number: DRV8350H-EVM Other Parts Discussed in Thread: DRV8350 , DRV5021 , MSP430F5529 I have referenced the DRV8350 EVM and have a new design , now it indicated my HALL SENSOR error. I have used the oscilloscope and measured the Connection end of…
Release 07_03_00_07 is default to use UART2.
I plan to change it to MCU_UART0.
It is fails on J7200 EVM. Nothing shows from MCU UART.
But I could change it to UART0.
The same binary could not run on our hardware. Even nothing shows from UART0…
Part Number: TDA4VM I tried to remove the following part in board-support/linux-5.4.106xxx/arch/arm64/boot/dts/ti/k3-j721e-vision-apps.dtso
- &main_i2c1 {
- status = "disabled";
- };
And run 'make linux-dtbs' in /opt/ti-processor-sdk…
Part Number: DRV8350H-EVM Hi all Would you mind if we ask DRV8350H-EVM? We would like to confirm hall sensors connection in case of 1PWM mode and 6PWM mode. The type of hall sensor is single end type, right?(not differential output type) <6PWM mode> J2…
Hi Kailun,
I had initially assumed the sensors were removed by desoldering, but I now see that the customer cut the EVM board in order to remove the other sensors.
We do not recommend modifying the EVM board in this way. It is hard to tell if any…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: DRV8353 Hi,
Please let me know, will DRV8353 chip fails if I connect and run 60 degree placed (instead of 120 deg) HALL sensor motor
From datasheet I could see DRV8353 supports 120 deg…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: MOTORWARE , , DRV8353 I do not see a project Lab 11e for this kit in the Motorware files. How do I make one? I did all other labs that TI supplied to me for DRV8353RS-EVM. Now I need to spin…
