Part Number: AM3354 Tool/software: Hi experts
Our HMI product, which went into mass production in 2014, uses the AM3354 processor. However, in the latest batch of products, some units are experiencing issues where a warm-reset cannot be completed successfully…
Hi Minhyeong,
Thank you for posting to the Sensors forum!
If you are looking for a smaller EVM to evaluate the DRV5056, one option that you can do is get the HALL-ADAPTER-EVM . The HALL-ADAPTER-EVM is a breakout board that has a bunch of different…
Part Number: DRV8353RS-EVM Other Parts Discussed in Thread: DRV8353M , DRV8353 Tool/software: Hello, I want to drive a motor without hall effect sensors. Can I use DRV8353RS-EVM for this purpose? Also can I use DRV8353SMRTAT motor driver for this purpose…
Hi Shlomi,
Just in case, Can you check that the hall connections to the EVM and the jumpers on the EVM are similar to the image below? The configuration shown below is for digital hall sensors.
Also, while spinning the motor by hand, can you provide…
Hi Suy,
It is good that you are getting functionality when you power cycle the board at least. I'm not sure why your other motor is heating up.
1. I think the motor must be identified again if power is reset.
2. You can try to write the CLR_FLT…
Hi Wei,
I would just like to confirm a few points regarding the schematic;
HMI with 927 Serializer --> Connect to 940N EVM --> Good LOCK and PASS HMI with 927 Serializer --> Connect to custom layout 940N (schematic above) --> No LOCK or PASS
From…
Part Number: DRV8353RS-EVM Tool/software: i am running my BLDC motor with DRV8353RS EVM kit with ISO-F28027f MCU board and i am controlling the motor with DRV8353Rx GUI. But when i start my motor then motor starts rotating but the fault led remains on…
Hello,
Thanks for the quick update.
This shows that no inputs are being sent from the MCU.
Double check your hall sensors and make sure that they are connected correctly.
I assume you have the board mounted correctly, but double check that just…
