Part Number: HD3SS6126 Hi, I wanted to know if there is a max trace length requirement from USB connector to the input of the mux hd3ss6126 on the PCB? We are running at 10G speed grade. To further clarify, I'm talking about the below trace lengths…
Part Number: HD3SS6126 Other Parts Discussed in Thread: HD3SS3220 Dear Team,
Thanks for your great support on this thread.
1. 0.33uF capacitors have been connected in series to USB SS RX_P and N on the SOC side.
BTW, they have 2 questions as below, could…
Part Number: HD3SS6126 Hi!
I’m using part# HD3SS6126RUAR in an application where I only have USB 2.0 highspeed signals, and was wondering what is the recommended method to terminate the USB 3.0 superspeed signals if there are none – can I leave them unconnected…
Part Number: HD3SS6126 Hi,
For better SI, we are planning to use 0201 AC caps on USB 3.0 nets. The datasheet says 0402 is recommended. Do you see any issues using 0201 size AC caps.
Thanks
Part Number: HD3SS6126 We have an USB 3.0 MUX requirements .Refer the below block diagram .
The HS & SS signals are the inputs to Mux from Processor or Host controller. We prefer to use one common USB 3.0 port to switch between the direct SS & HS signal…
Part Number: HD3SS6126
Hello,
In a drawing of HD3SS6126's WQFN package (RUA) in the data sheet, what appear to be metal exposed outside are seen. I'd like to confirm if these are really metal or not.
Best regards, Shinichi Yokota
Part Number: HD3SS6126 Hi,
My customer indicated that he needed the function that there is no signal output after the chip is powered off, and there is no need for compensation. According to customer requirements, it is only used as a switch. HD3SS6126…
Part Number: HD3SS6126 Hello
We required USB 3.0 Switch for our design.
In HD3SS6126RUAR ,enable (HS_OE) is only given for USB 2.0 .
If
HS_OE =0
SEL=0
Then HSA to HSB will active (USB 2.0 port is selected)
So on the same time USB 3.0 port will select…