Part Number: IND-COMMS-SDK
Tool/software:
Hi, in the BSP, the Sync0 interrupt is triggered via a task (Sync0task()). With other interrupts in the system, the Sync0_ISR jitter is relatively strongly. There is a macro in the BSP:
The macro is also…
Part Number: IND-COMMS-SDK Other Parts Discussed in Thread: PROFIBUS , Tool/software: I was looking at an old white paper document Profibus on AM335x and AM1810 Sitara ARM Microprocessor White Paper (Rev. B) that (+) PratheeshGangadhar's Profile - PratheeshGangadhar…
Part Number: IND-COMMS-SDK
Tool/software:
Hi,
the configuration of the latch inputs to the single event mode does not appear to be possible via the PDI (register 0x9A8/0x9A9). There are no timestamps either. In the "ESC" tab list, the tabs are shown…
Part Number: IND-COMMS-SDK Tool/software: Hi,
we are using the AM243x with ICSDK 11 and Profinet. The ICSS is configured as a switch. Is it possible to allow a second MAC address without configuring Dual-MAC Mode?
Regards,
Matthias
Part Number: IND-COMMS-SDK Tool/software: Hello,
My customer is considering AM243x for function safety machine.
I believe there is option part number for use TI provided stacks.
Do you have plan for provide stacks that compliant function safety…
Part Number: IND-COMMS-SDK Tool/software: Hi
May I have question about SDKs of AM243/64?
I found 2 version of industrial communication SDK.
IND-COMMS-SDK and INDUSTRIAL-COMMUNICATIONS-SDK-AM243X(in MCU+SDK)
https://www.ti.com/tool/IND-COMMS-SDK…
Part Number: IND-COMMS-SDK Other Parts Discussed in Thread: AM2432 Tool/software: Hello team,
I develop EtherCAT subdevice application with AM2432 and de83822.
Link detection works fine via MDIO, but not via the PHY's GPIO.
This is how I set…
Hello Oyama,
Kindly use the toolchains recommend by Ind-comms-sdk 11.0 and use the syscfg file from sdk11.0 example. I integrated your FoE changes in EtherCAT Simple demo from Ind-comms-sdk 11.00.00.08 and I could not reproduce the issue. Could you…
Part Number: IND-COMMS-SDK Tool/software: Hi team,
I'd like to know about specification of EtherCAT error indicator of SDK ethercat subdevice demo for AM243x.
In addition to the ETG1300 Mandatory requirements, are there any Error lighting assigned…
Part Number: IND-COMMS-SDK Tool/software: Hello, I'm confirming configuration to run ethercat simple demo on AM243x-LP.
I'm now checking following page to understand hardware configuration. https://software-dl.ti.com/processor-industrial-sw/esd/ind_comms_sdk…
