Part Number: ISO7220C Other Parts Discussed in Thread: ISO7220 , ISO6720-Q1 , ISO6720 Hi Team,
There is a good new that we DIN ISO7220CDR!
But cause ISO7220CDR is out of stock!
So customer is looking for the replacement of ISO7220CDR
I think maybe I SO6720 …
We bypassed the on-board JTAG circuitry and connected an external JTAG board ( https://www.olimex.com/Products/DSP/Emulators/TMS320-XDS100-V3/ ). This worked well for all of the boards. Then we traced the JTAG comms back and found that there was a change…
Hello,
I changed my isolators for the ISO7320C : results are really better, but I still have sometimes EMI problems (inverter bridge that comes in error mode).
I made a new PCB to use the ISO7842, but results are worst than with the ISO7320C althought…
Not really,
24V input voltage. There are 5 DRV8432 motor drivers in my design driving .5Amps or so, switching currents may be higher...
but the debugger is completely isolated by ISO7220C isolators (+ a 1Meg bleeding resistor connecting DebugGnd to Gnd…
Jay,
If you want to use the external XDS510USB, you'll need to change the ISO7220C isolater ICs that are included with the kit. We've noticed in the past that, for some reason, that 7220C transmission rate is too low for some of the faster external debuggers…
Other Parts Discussed in Thread: TMS320F28027 , TEST , ISO7220C , XDS100 , C2000-GANG I have tested the program with TMS320F28027 launchpad.
It has successfully loaded and was tested successfully.
However, when I had tried to load same program into TMS320F28027…
Other Parts Discussed in Thread: TEST , XDS510 , TMDSCNCD28069 , TMDSHVMTRINSPIN , ISO7220A , ISO7220C , ISO7220M Hello everybody,
I would like to use a XDS510 JTAG probe (from spectrum digital) on the TMDSHVMTRINSPIN HV kit (which uses the TMDSCNCD28069 µC card…
Problem found and resolved.
In the implementation of the emulator, based on the Experimenter's kit , four optocouplers were added to interface with ControlCARD.
The error was the specification for the optocouplers: ISO7220A (1 Mbps signaling rate…
