Part Number: ISO7821LL Other Parts Discussed in Thread: ISO6441 Hi,
I have an application where I am using this part to isolate LVDS signals, but also need to isolate a pair of single ended, unidirectional signals. Can the ISO7821LL be used as a single…
Part Number: ISO7821LLS Tool/software: Hello,
In my application for CAN communication, I need a minimum air gap of 15mm. According to the data sheet, the digital isolator ISO7821LLSDWWR has a minimum air gap of 14.95mm in the worst case. Now the question…
Part Number: ISO7821LL Hi Team,
A customer is looking for an Isolator for a camera circuit of an endoscope system. The camera has a MIPI CSI interface and uses 1 lane of data (27Mhz max clock speed)
I found threads suggesting this device but I am…
Part Number: ISO7821LL HI，
When I use ISO7821LL to isolate LVDS signal，I want to consult some questions，
there are some points you can attention in my device:
1.Ethernet cable and RJ45 are used to connect my two devices.
2.LVDS signals are transmited…
Part Number: ISO7821LLS hello team,
we are looking for and isolation for our project which has mipi csi2 and we came to know that ISO7821LLS has an data rate of 125 Mbps But we need minimum of 900 Mbps data rate. can you suggest any other ic for this…
Part Number: ISO7821LLS Other Parts Discussed in Thread: ISO7821LL , Hi Team,
our customer is looking for isolator for MIPI CSI-2 interface due to safety concern, they find ADN4654 can support MIPI CSI-2 isolator. do you have similar devices? or we…
Hi Kailyn,
The LVDS isolator family has two kinds of devices - ISO7821LL & ISO7821LLS (note the difference between part numbers, this part has an additional 'S' added at the end). ISO7821LL does support datarates from 0-100Mbps while ISO7821LLS only…
Part Number: ISO7821LLS Other Parts Discussed in Thread: ISO7821LL Hello,
I would like you to confirm about below.
* I would like to make sure detail of Distortion correction function which have ISO7821LLS.
From viewpoint of block diagram, I understood…
Part Number: ISO7821LL Hi,
The A/D converter is affected by AC main 60Hz noise from RJ45 connector, so there might be another way of using ISO7821LL (with ultra-low isolation capacitance 0.7pF) between LAN Magnetics and MSP432E401 PHY. Is there any…
