Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: CC1310 , CC1190 , Dear support team,
We are developing new project for outdoor vehicle telemetry system in tracks. We are using CC1310 at 868MHz for Europe and 915MHz for US. For this project…
Part Number: LAUNCHXL-CC1310 Hi team,
Here's an issue from the customer may need your help:
Pins used under the sensor controller cannot be used in the main reference program. Thanks.
Best Regards,
Cherry
Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: CC1310 , Hi team,
Here's an issue from the customer may need your help:
With the watchdog, reconnecting after a network break causes the watchdog to wait for a reset directly at the ICall_wait…
Part Number: CC1310 Hi All,
Excuse me if my post is not in right forum.
I have designed a gateway board using CC1310 as an SPI slave to an other master MCU to read temperature measurement from remote sensors. Sensors are also designed around CC1310.
…
Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: SIMPLELINK-CC13X0-SDK , CC1310 , BOOSTXL-SENSORS Hello Community,
I have purchased CC1310 LaunchXL and BoostXL-Sensors (Sensors BoosterPack Plug-In Module) and was working on these TI-Tools I…
Part Number: LAUNCHXL-CC1310 Hi,
Is there a mode or something I can select so that we can use TI-RTOS as a non-preemptive scheduler? Or is TI-RTOS only suitable for preemptive scheduling?
We don't want our tasks to be interrupted during execution, but…
Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: CC1310 I have a rookie question and decided to take my beating and potentially get an answer vs. continuing to beat my head against the wall wondering why.
I am using Code Composer Studio version…
Part Number: LAUNCHXL-CC1310 Hi there, I've been working on adding the DS18b20 utilzing maxim's onewire protocol to my project with the CC1310-LaunchXL, but I've been struggling to be able to make some of the functionality work. I have tried to use the…
Part Number: LAUNCHXL-CC1310 Other Parts Discussed in Thread: CC1310 Hi,
we want to change the tx.power to -10dBm for testing the HSM with our CC1310 Launch-Pad.
At the moment we have 13/14dBm when we send packets with the example.
How can we change this…
Part Number: LAUNCHXL-CC1310 Hi,
I'm working on rfPacketTx and rfPacketRx succesfully where two launchpads are communicating. I would like to implement a feedback method where the receiver device can send a 'OK' to the emmiter when packet is sent. Thus…