Part Number: LDC-DESIGN-TOOLS Tool/software: Hello,
Could you please check the following issue on TI Webench Coil Designer :
URL: webench.ti.com/.../
Issue: When trying to export any coil design to a PCB project , the export fails with the following error…
Hi Patrick,
Patrick Simmons said: Per the inductance value estimated by the scaling factor, it is smaller than the inductance calculated by formula (7) in the datasheet.
So the inductance value calculated with the LDC0851_calc is smaller then the formula…
Part Number: LDC1101 Tool/software: I have used the old online version of the LDC Design Tool in the past. Had no issues with it and was easy to use.
Using the new spreadsheet version:
For this project, I am considering the LDC1101. I downloaded the…
Christian,
For your design to work, you would need to set the ratio to 1 to generate the off axis coil. This will not generate the correct target for you though. In order to have a 5 pole target, you should set the tool back to angular co-axial and set…
Part Number: TDA4AL-Q1 Tool/software: I refered https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1058565/faq-tda4vm-how-to-create-a-ldc-mesh-lut-for-fisheye-distortion-correction-on-tda4 this FAQ for creating the Lut for a image…
Part Number: TIDA-010049 Tool/software:
Dear all,
I am working on the same topic, is it possible to get the following two documents for me as well?
1. FMEA > TIDA-010049- Concept_Evaluation.docx v0.91
2. Review report > Review Protocol Concept…
Hi Wayne,
I'm sorry to hear that you're experiencing issues with these tools. Webench is a great, user-friendly tool to get you started, as it provides an initial schematic. However, I recommend using the Excel tool to review the schematic afterward…
Part Number: UCC28950 Tool/software: Mike,
I have not H bridge at the output actually my intention is to identify whether the ic working or not.
Without connecting H bride is it possible to generate pulse at the output?
output pins are open
Part Number: UCC28950 Tool/software: I tested ucc28950 in open loop what you have mentioned in previous discussion
I have connected error amplifier in voltage follower mode and applied variable power supply at the EA+ pin but still output zero.
the voltage…
