Part Number: LDC-HALL-HMI-EVM Other Parts Discussed in Thread: TMAG5273 , TMAG5273EVM Tool/software: Hi, We have a LDC-HALL-HMI-EVM, but we would like to be able to read the axes of the TMAG5273 chip on the board like the TMAG5273EVM_GUI. Is there a possibility…
Hello Jacques,
Glad the EVM is working for you now. Thanks for your feedback on it working on the desktop but not on the cloud GUI. We will make sure to look into that a bit more.
Let us know if you have any other issues.
Best Regards,
Justin Beigel
Part Number: HALL-TRIGGER-EVM Other Parts Discussed in Thread: DRV5032 Tool/software: Hi, Could you please suggest an alternate with Lower cost with same Pin & similar Package for below MPN: AH180N-WG-7 (Hall Effect Switch). Maximum output voltage…
Part Number: DRV8350H-EVM Tool/software: Hello.
I am John. I am designing a BLDC motor drive with DRV8350H.
I am writing this because I have a question about the circuit design.
My product receives PWM speed command from an external MCU and operates a…
Part Number: DRV8350H-EVM Tool/software: Hello.
I am John. I am designing a BLDC motor drive with DRV8350H.
I am writing this because I have a question about the circuit design.
My product receives PWM speed command from an external MCU and operates a…
Part Number: SK-AM62 Hello
I would like to use the SK AM62X EVM as a communications Gateway ( HMI ) - and to interface it to a C2000 family - like the F28379 or F28388D - Where can i find that the manual ? Or can you give me the approach on how to inteface…
Ryder,
We have a ref design that uses the LDC1314 inductive sensor for angle estimation: https://www.ti.com/tool/TIDA-00508 . It is oriented towards 1deg absolute accuracy and 0.1deg resolution, but it could serve as useful starting point. A higher resolution…
Jin,
There are instructions for re-setting the EVM firmware on the [(E2E] Inductive Sensing Frequently asked questions page.
Please see Q36 - I have 'bricked' my LDC1312, LDC1314, LDC1612, or LDC1614 EVM during a failed firmware upload attempt. What can…
Kaan Berke Ulusoy said: I have set it to 3840 x 2160. I did it when you first mentioned about it.
However, I still got the problem.
I suppose you would only need to modify these 3 lines in single-cam app to match your actual LDC settings in DCC.
#define…
Hi Jiarong,
Zhang Jia Rong said: But when I used the DCC tool to save the image(yuv), I found that it was completely different from the image displayed on the monitor.
Tuning tool captures the YUV image output from VISS which has not been processed by…
