Part Number: TDA4VM Tool/software: Platform Details:
Processor: TDA4VM (Custom Board)
Linux SDK: ti-processor-sdk-linux-j7-evm-08_01_00_07
RTOS SDK: ti-processor-sdk-rtos-j721e-evm-08_01_00_13 We are working with a TDA4VM-based custom…
Hi Suren Porwar
Now I use TI_AM62pxx_HyperCluster-1920x720_demo-latest.7z and rebuild it in my 11.1 SDK sysroot , generate the newer binaries
there is build log , you can check it
Fullscreen
3480.build_log.txt
Download
[linux-devkit…
Hey Francois,
The DRV8363-Q1 EVM was built for compatibility with LAUNCHXL-F280049C. In one of our initial revisions we had challenge running HALL C to J9.17.
The Hall signal would not toggle which affected Hall based commutation. Therefore, We…
hi
Brijesh Jadav said: Can you share the split of these cameras between two VPACs?
Currently, we have evenly allocated the tasks for the two LDCs. The time consumed by VPAC1 LDC is 35ms, and the time consumed by VPAC2 LDC is 11.8 + 3.7 + 17.5 = 33ms…
Part Number: TDA4VM
Tool/software:
Platform Details:
Processor: TDA4VM (Custom Board)
Linux SDK: ti-processor-sdk-linux-j7-evm-08_01_00_07
RTOS SDK: ti-processor-sdk-rtos-j721e-evm-08_01_00_13
We are using a TDA4VM-based…
Hi Henry,
Thank you for your interest in the DRV8353R EVM.
You are correct, unfortunately this board only supplies 3.3V to the hall power.
The DRV8353 Device itself will work just fine with this motor, but unfortunately the board was designed without…
Hi
There is no errata or issue observed with PWM frequency.
How are the HALL sensors are connected? Can we verify the HALL type and biasing recommendation including noise filtering as per data sheet?
Are you testing it on EVM?
Please share motor…
Hi Wataru,
Verified for the condition 1, with one HALL fault will not detect and it requires 2 HALL to be disconnected.
For the observation in condition 2, possibility is wrong commutation can be driving motor at low efficiency and causing over temperature…
Kel,
You may be interested in the LDC Coil EVM, which provides many coils that you can test with.
https://www.ti.com/tool/LDCCOILEVM
To generate your own coils, you can use the Webench tool below. This does not generate the shielded routing. You…
Hello,
I have not personally used one in a design. Theoretically you should be able to use one in your design.
I would suggest ordering a UCC28950EVM and see if you can modify it to use a hall affect sensor.
The following link will bring you to…
