Part Number: LM4951 Other Parts Discussed in Thread: , LM4950 Tool/software: Hi,
I wanted to download the lm4951 and lm4951A spice models for simulation.
I could not find it in the TI website and in the pspice library.
Where can I get it?
…
Part Number: LM4951 Tool/software: Hi All, In my design, we use the LM4951 amp.
After some customer feedback, the audio amp under unknown condition was shorted and there was click-pop sound during the turn on.
Also, there is a low level / continuous…
Part Number: LM4951 What's the difference between LM4951 and LM4951A, we have encountered click and pop problem after we displaced LM4951A with LM4951.
VDD is 7.5V and the speaker's nominal value of resistance is 8 ohm.
The part of schematic document…
Part Number: LM4951 Hi team,
my customer would like to use LM4951. Then I got some question.
Could you give your advice?
1. The customer would like to use single-ended. To use for single-ended, the customer should add coupling capacitor. Is this…
Part Number: LM4951 Hello everyone,
I have recently downloaded a big database of PSPICE models from Texas Instruments (see http://www.ti.com/adc/docs/midlevel.tsp?contentId=31690&DCMP=hpa_tools&HQS=spice ); however, the device I need to simulate is…
Other Parts Discussed in Thread: LM4951 this is kind of a reliability question.
The LM4951 is spec'd for 9V max operating voltage. What's the effect (or, is it even recommended) if it were to run slightly higher, say 1%, or 3%? (around 9.1 or around…
Part Number: LM4901 Other Parts Discussed in Thread: LM4951 , Hi
I would like to understand more does this device have the same THERMAL SHUTDOWN AND SHORT CIRCUIT PROTECTION like LM4951?
and if I'm not mistaken there should be a Shutdown resistor…
Hi, Luke,
1. The TPA6211A1 can be used with only one output. The other one can be left floating as you mentioned. However, as I mentioned before, it can only reach a reduced power output, 4 times lower than the output power in differential configuration…
Part Number: LM4951A Other Parts Discussed in Thread: LM4951 Hi all,
we encountered weird behaviour of the LM4951 amplifier when using an small 0402 ceramic 1uF capacitor as CBypass. (VDD=7.2V, Cs=1u 50V X7R 0805, Ri=20k, Rf=100k, Rc=1k) On the Bypass…
