Part Number: LM92 Tool/software: I'm considering using the LM92.
I couldn't find it in the datasheet, so please tell me the following specifications.
(i) Operating and storage humidity range.
(ii) Operating and storage vibration conditions.
(iii…
Part Number: LM92 Other Parts Discussed in Thread: TMP1075 , TMP275 , TMP112 Hi team,
Several questions on I2C setting for the device.
1. During the POR event, does I2C bus go idle as well? (No need to apply 9 clock or other reset through I2C?)
…
Part Number: LM92 Hi there,
I'm hoping that someone out there has had a similar issue and managed to solve it.
Basically, I am sending the control byte, comprising 0b10010011 (read temperature from user device address 01), but the byte only gets as…
Part Number: LM92 Other Parts Discussed in Thread: TLV1701 , TMP117 Hi Team, I would like to request for your assistance if we have a possible TI solution for the customer request for a comparator for temperature sensing application. He uses two pt1000…
Hi Chris, LM92 is a long-time released device from National's folks that were no longer with us. The operating range for the temperature is from -40°C to 150°C; however, we only specified the temperature accuracy is from -25°C to 150°C. Anything out beyond…
Other Parts Discussed in Thread: LM92 Hi,
LM92 I2C read timing。
Data-sheet (SNIS110D) page13 Figure9 timing is asked.
"Ack" (Low) is output more than master next to D0.
I think the place and the master reads take NACK (High) out of the specification…
Hello Franco
Note, that the I2CMasterBusy condition has been used with both true-false condition. Putting a breakpoint before can create conditions for such a case to occur,\,
But thanks for posting the image: A good case of where not to put a Break…
Other Parts Discussed in Thread: LM92 Please let me know about meaning of LM92's configuration resister "D5 ～D7".
(Datasheet P13 Table-4)
Customer evaluating LM92, but D7-resister changed "1".
What is the cause which becomes D7："1"?
Is it no problem…
Other Parts Discussed in Thread: LM92 At first, a few time ACK was OK, but soon (after transmitted) LM92 does not ACK.
Please let me know 3 point below.
・Is there considered cause?
・When accessing continuously, is the special command needed?
…
