Part Number: LMH0302 Other Parts Discussed in Thread: LMH0303
Dear TI,
I have a design where I'm using GS12190 as HD-SDI cable driver and is working perfectly fine.
This circuit, I replaced with LMH0302 to get better SWaP. Here is the circuit
…
Part Number: LMH0303 Hello, I am using the LMH0303 and cannot fin the Minimum Input data rate in the data sheet.
I specifies a maximum, but no minimum. The interface we will be driver requires 160Mbps.
Will this device work?
Part Number: LMH0303 Hello Team,
Please Provide Shelf-Life Value for the Part No: LMH0303SQ/NOPB
We are looking for shelf life of component which means how long the component can be stored before use or before unpacking.
Regards,
Santhosh S +91…
Part Number: LMH0303 I would like to ask about the termination resistor configuration for the SDI input pin of the LMH0303. In the datasheet, the configuration uses two 49.9-ohm resistors and one 0.1uF capacitor.
On the other hand, the evaluation…
Part Number: LMH0303 Tool/software: Hello,
In my design using the LMH0303, the Fault pin is pulled up to 1.5V using a 1kΩ resistor, even when the device is powered off.
Could you confirm if this setup is safe and does not cause any issues?
Thank…
Part Number: LMH0303
Hi. Please look in to the document attached . when we detect the signal in display it looks blur . So we have done with Signal intgrity and attached the file please gothrough in detail and help us to resolve the issue .
it on…
Part Number: LMH0303 Other Parts Discussed in Thread: LMH0318 Dear Team,
I would like to inquire about the rationale behind the circuit configuration for the LMH0303, specifically regarding the proper handling of the /SDO terminal (pin 11) in single…
Part Number: LMH0303 Tool/software: Dear Team,
I am currently facing an issue when attempting to configure the lmh0303sq.ibs file within the ADS simulation software.
Specifically, when I try to set it to IBIS_DIO /DO/IO , I receive the following error…
Part Number: LMH0303 Other Parts Discussed in Thread: LMH0307 , Background:
The LMH0307/3 termination fault detection was never designed to be precise; its purpose is to provide an indication when no cable is connected to the output (near end). The…
Part Number: LMH0303 Tool/software: Hello,
We use LMH0303 for HD-SDI output in our project, 2 such instances onboard.
Measuring each of the 2 interfaces, the results we get are outside of Spec, in terms of amplitude, rise and fall time.
For channel…
