Part Number: LMT85-Q1 Hello,
What are the minimum and maximum values of the tolerance, for the yellow highlighted Test condition in case of temperature sensor LMT85QDCKRQ1?
Also do you have these values (Min., Max. tolerances) for the test condition…
Part Number: LMT85-Q1 Hi TI support,
I am looking for the lookup table to calculate temperature with input reading from the LMT85-Q1,
data sheet says the table is available from a link to TI site under software/tools, but it is disabled for
this…
Part Number: MSP430G2553 Other Parts Discussed in Thread: LMT85-Q1 , MSP-FET
This is my circuit. I'm feeding the LMT85-Q1 from the P2.1 of the MCU. Pin 2 on the MCU (A0) is used for reading the output from the sensor.
#include <msp430.h>
/…
Hello Given,
The link below shows all analog sensors which support -40C to 150C and are available in SC70(DCK) 5 pin package. TMP9A00-EP is the only device with the same gain of -11.77mV/C. If you can use a different sensor gain, TMP235 is a good candidate…
Part Number: LMT86 Other Parts Discussed in Thread: TMP235
Team,
Apart from the different LMT86 OPNs ( LMT86 vs LMT86-Q1 ) do we have some P2P dropped-in alternatives for LMT86QDCKRQ1 ? Apart from the mV/Deg C difference what would need to be taken…
Part Number: LMT85 hi,
Is the correct functional behaviour of LMT85-Q1 impacted if inadvertently PIN5 has been connected to VDD instead of GND? if yes, to which extend?
thanks,
Ulrike
Hi Jalen,
Thanks for your quick response.
I already had recommended to use 1.5 kohm series resistor as LMT84-Q1 datasheet recommended and as explained in the below e2e post.
https://e2e.ti.com/support/sensors/f/1023/t/682737?tisearch=e2e-sitesearch&keymatch…
