Part Number: LP5018 I see that all registers will be reset by toggling the EN pin (pin 30) from High to Low and back to High. I assume that this will put the device back into its original power on state, but I want to make sure I don't miss anything.…
Part Number: LP5018 Other Parts Discussed in Thread: LP5024 Hello,
I would like to use LP5018 LED driver and have few additional questions:
1. It is possible to power LEDs from higher voltage than LP5018 itself (LP5018 powered from 3.3V rail and LEDs…
Part Number: LP5018 Hello team,
I received some questions from my customer about I2C rise/fall time of LP5018. It may be a basic question, but I would appreciate if you could give us an advice about it.
The TR/TF for I2C in LP5018 appears to be listed…
Part Number: LP5018 Hi,
I would like to ask you how to use the LP5018. (question 1) Is it okay to understand that the current can be adjusted for each of the 18 LEDs? Is current adjustment a method of changing the current value itself? Or is it a method…
Part Number: LP5018 hi：
i use single lp5018，and set device address 0x28，i use iic to initial the lp5018，config regist as follow：
DEVICE_CONFIG0 reg = 0x40， DEVICE_CONFIG1 reg = 0x3f，
LED_CONFIG0 = 0，
and i set LED0 brightness = 0xff,
lLED0 OUT0_COLOR =…
Part Number: LP5018 Hello Support team,
LP5018 has IRFE pin and this is used as setting maximum value of sink current. Can LP5018 set DC sink current on each OUTs individually? And does color-mixing and brightness-control means to set target duty value…
Part Number: LP5018 Hi team,
My customer would like to design LP5018 but he had a bad experience before about TI device EOL problem.
So he would like to know will LP5018 be EOL during next years? Any TI system can check device's status?
Thanks
Part Number: LP5018 Hello Expert, My customer has question for LP5018. They has concern about EMI performance of LP5018. Do this device has any feature for EMI?(I guess phase shift function work effectively for EMI performance) I'm looking forward to hearing…
Part Number: LP5018 Hi Team,
My customer measured the SCL low period time is only 1.26us which is less than SPEC 1.3us. Will have any concern for this one? Can we use standard to measure it?
Note. The concern is from due our device VIH and VIL definition…
