Part Number: LP5816 Tool/software: Can I use it to drive three LEDs in series with a 12V supply? When current is flowing, each LED has a forward voltage drop of about 3V, so the voltage drop on the chip’s pin is around 3–5V. However, if the drive current…
Part Number: LP5816 Tool/software: Hello team,
How long is the time reflected in LED output after sending the on/off command via I2C? I could not find the spec in the datasheet.
Best regards,
Shotaro
Part Number: LP5816 Other Parts Discussed in Thread: LP5861T
Tool/software:
Hey Team! I'm a bit confused how this device works. Sorry I made a typo and the device should be LP5816T
I was also wondering if we wanted to use this part to drive 12…
Part Number: LP5816 Tool/software: I have a laser diode application needing up to 60mA of drive current. It works synchronously with other system sensors.
I want to be able to vary the current from 0mA to 60mA at 1mA resolution or better. It's desired…
Part Number: LP5816 Other Parts Discussed in Thread: TPS61196 I need help locating a TI IC that has the following key specifications: I2C bus, min 4 Channel PWM, 8-bit duty cycle resolution, 5Khz capable PWM base frequency running at 3.3V. These PWMs…
Part Number: LP5816 Other Parts Discussed in Thread: LP5815 Tool/software: Hi All, We are currently using LP5816 for led control. I can able to achieve solid white LED behavior with below configuration. i2c dev 0; i2c probe; i2c mw 2c 0x0.1 0x01 i2c mw…
Part Number: LP5814 Other Parts Discussed in Thread: LP5816 , LP5817 , LP5815
Tool/software:
Four steps to solve the I2C NACK,
Hardware check
Device I2C slave address check
Real output I2C data bits check
SCL / SDA high low level check …
Hi Parv,
Sorry, I misinterpreted the part number.
Do you have the I2C pull-up resistors on the PCB? Can you please check the hardware configuration so we can rule out hardware issues?
[FAQ] LP5814: How to solve NACK when send I2C command to LP5814…
