Part Number: LSF0102 Other Parts Discussed in Thread: LSF0204 , , TXU0101 , SN74LVC1T45 Tool/software: Hi Team, Attached are the schematics for your reference. Please let me know if any changes are required. A few notes/questions for clarity: I connected…
Part Number: LSF0102 Other Parts Discussed in Thread: TXS0102 Dear Team,
Currently, there is a case where LSF0102DCTR is used and the signal high level of Port B does not reach the voltage of Vref_B (4.2V), only about 2.2~2.3V. The Port B signal is…
Part Number: LSF0102 Hi experts,
Want to know the internal MOSFET architecture about LSF family. From training video said it is a four pin MOS, and from the illustration, base side connect to GND and Gate connect to Vbias.
1.Can you provide details…
Part Number: LSF0102 Tool/software: Hi,
Based on the example below, the pull-up resistors on both sides of the LSF0102 should be the same, right?
If they are required to be the same, what would be the impact if different resistor values are used on…
Part Number: LSF0102 Tool/software: Hi Team,
what is the current consumption of VrefA and Vref B pins?
In datasheet 64mA is mentioned as pass transistor current.
Thanks,
Vidhya
Part Number: LSF0102-Q1 Other Parts Discussed in Thread: LSF0102 , TXU0304-Q1 Hi team,
Is LSF0102 device internal open drain? According to the d.s. application circuit the input and output both need pull up resistor. Customer want to use this device…
Part Number: LSF0102 Other Parts Discussed in Thread: LSF0002 Hi Support
I want a part for IO level shifting between 1.2V and 1.8V. IO could be push-pull or open-drain. And I want auto bi-direction.
I found LSF0102 may fulfill the requirement. And…
Part Number: LSF0102 What is the leakage current for Vin=0V, Vref_A/B=0, but there is input on A1/A2 for I2C. The happens for single supply working situation(supply from wireless charging Rx), but need normal house keeping I2C working, what is the leakage…
Part Number: LSF0102 Tool/software: Dear Team TI,
I was looking forward to include LSF0102QDCURQ1 level translator in my design and wanted to do DC analysis between processor to level translator and sensor to level translator to check compatibility…
Part Number: LSF0102 Tool/software: I would like to ask about the usage of VrefB on the LSF0102DQER.
From the datasheet, VrefB and EN are connected together first and then pulled up through a 200K resistor.
In my current design, only EN is pulled…
