Part Number: MAX3232E Other Parts Discussed in Thread: MAX232 Tool/software: Hi All,
We are using MAX3232E in our design for UART-to-RS232 conversion. We need to provide flow control signals(CTS & RTS) from MCU to RS232 connector. Which signal i need…
Part Number: MAX3232E Tool/software: We are currently designing a product that will incorporate ISOLATED RS232 For that i am using MAX3232E and ISO7742DWR
, with an estimated annual volume of approximately 3,000 units . As part of our design planning…
Part Number: MAX3232 Other Parts Discussed in Thread: TRSF3223E
Tool/software:
Hi, TI expert
When the customer connected MAX3232IPWR(TI) and MCU(STM32F446RETx) as shown below, the current consumption seems to be more than what is stated in the spec…
Part Number: MAX3232 Hello E2E Experts,
MAX3232 3-V to 5.5-V Multichannel RS-232 Line Driver and Receiver With ±15-kV ESD Protection datasheet (Rev. O)
I am looking into this IC for one of my designs but I have some questions that the datasheet doesnt…
Part Number: MAX3232E Tool/software: BATCH CODE OF THE IC IS INDICATED AS 36K G4 AVTK
PLEASE CONFIRM THE DATE OF MANUFACTURE AND ALSO MANUFACTURING SITE
Part Number: MAX3232 Tool/software: Hello experts, I'm reaching out on behalf of one of our customers, to check whether our RS232 Transceiver MAX3232 3V-5.5V Is compatible with the following processes, and up to which level?
Automatic washing (water…
Part Number: MAX3232E Tool/software: Hello TI team,
The customer used MAX3232EIDBR and found an abnormal voltage at Pin 3 during ICT testing, so they determined that the IC is faulty
They determination criteria, Pass >1.4V, fail = 0.59V
The…
Part Number: MAX3232E-Q1 Hello Team ,
Usig MAX3232EIPWR as the interface IC between the UART lines and RS232C components .
Observed the sawtooth pattern waveform on the DOUT lines and RIN lines .
Please suggest proper solution to resolve the issue…
Part Number: MAX3232E-Q1 Hello team,
My customer have below questions regarding C1~C4 in typical application, can you support please?
Vcc=5V, is it okay to use 3V to 5.5V table? They want to use 0.47uF for C2~C4 especially.
Should they consider…
