Part Number: MSP430F122 Tool/software: FCT test failure , Due to the same adverse phenomenon, J3 voltage is too low, Defective rate: 12%
After analysis and verification, it has been preliminarily confirmed that IC U5 has poor functionality
1. Heating…
Part Number: MSP430F122 Tool/software: hi,
Any recommendation to replace CY7C68013A-56LTXC which is a USB 2.0 Peripheral controller?
according to "cross -reference search", MSP430F122 is recommended, but it should be not match with cy7c68013A.
…
Part Number: MSP430F122 Other Parts Discussed in Thread: MSP-FET Hi Ti,
I want to use MSP430F122 microcontroller,
To program this i need to use MSP-FET in 4 pin JTAG mode
The OS available from windows 7 ,10
The work bench IAR 7.1, 7.2
Will MSP…
Other Parts Discussed in Thread: MSP430F122
Dear Sir/Madam,
We encounter problem in programming the flash of MSP430F122. The following messages appeared in the BSL message dialog box.
11:01:30 Initialize... 11:01:31 Device: MSP430F12x. Info…
Thank you Jason for your reply! I was planning on using the MSP430F122 but I think I'll switch to an MSP430F5X since it's cheaper and has more available pins. Do you have any recommendations? The primary feature I need is a UART port and one or two DIOs…
Other Parts Discussed in Thread: MSP430F122 , UNIFLASH , MSP-FET Hello,
This should be simple but I can't get it
I was given a .hex and .out file made from code composer for a MSP430F122. I am using the MSP-FET to attempt to load the program.…
Other Parts Discussed in Thread: MSP430F1222 , MSP430F122 Hi,
I am trying to write a simple software to blink a LED light on GPIO pin on MSP430F1222 MCU.
Compilation works fine but the linker doesn't work well.
After downloading the firmware to…
Other Parts Discussed in Thread: MSP430F122 , MSP430F2350 I was looking at the TI MSP430F122 mixed signal controller and noted that there were two equations relating the the frequency and VCC to the active current of the device (below).
current…
