Sir actually i am unable to run this LCD with msp430f427a , in which LCD module is there , i am trying all possible solutions but still i am unable to do it .
Other Parts Discussed in Thread: MSP430FG4250 , MSP430F427A Tool/software: Code Composer Studio Hello!
I have successfully interface LCD with MSP430fg4250 and MSP430g6626. Currently I am working on MSP430f427A but I am unable to interface successfully.…
Hello,
To isolate whether this issue is related to your board, I would recommend purchasing a target socket board for the MSP430F427A and use a signal generator as the differential input to the Sigma Delta ADCs. Let me know if you still see these pulses…
Part Number: MSP430F427A Other Parts Discussed in Thread: MSP430-FLASHER , UNIFLASH Have a s/n 16... MSPFET that works fine w/ 1.3.11 MSPFlasher under win XP.
Got a new MSPFET s/n 17... which would not work. After investigating, it appeared I needed to…
Part Number: MSP-FET430UIF Tool/software: Code Composer Studio Hello everybody,
after reading many posts about this error I didn't get a satisfying result.
At the end the solution was very simple: It's not possible to work with a lauchpad ('5529…
I got this error when I compile the code... any solution ? Error[e16]: Segment DATA16_Z (size: 0xc99 align: 0x1) is too long for segment definition. At least 0x8a3 more bytes needed. The problem occurred while processing the segment placement command "-Z…
Other Parts Discussed in Thread: MSP430F427A I am using MSP430F427A with SD16 ADC for single phase energy meter application.
When I set the SD16 for higher sampling rate (4Mhz) then the sample values gradually decrease even if the input is kept unchanged…
Other Parts Discussed in Thread: MSP430F427A Hello, I work on an application and I use MSP430F427A . It's a sensor goes inside an oven, Oven temperature (125C) The line lenght 160-170 feet. The sensor moves inside oven 80 foot and its speed moving (150…
MSP430F427A doesn't support SBW (Spy-Bi Wire) interface, so you cannot program it using what is shown on Page 24. You need to use what is shown on Page 22.
