Part Number: MSP430F447 Hi Team, we would like to confirm if we already used 2 UART of the CPU, can we still add SPI peripheral as an upgrade?
Thanks!
-Mark
Part Number: MSP430F447 Other Parts Discussed in Thread: THS1206 , , ADS8342 , TM4C123FH6PM
Hello,
I received the MCU MSP430 Vs ADC THS1206 EVM source code from the ADC forum at the address below.
https:// e2e.ti.com/support/data-converters…
Part Number: MSP430F447 hi
i have used port pin to enable the motor and using through beam ir sensor i am stoping the motor
problem is in the below code first time its working properly second time the motor stops its not coming out of the while
…
Part Number: MSP430F447 Tool/software: Code Composer Studio hi
So far i have been using IAR but my code size has crossed 8k so can u suggest me some open source tool so that i can run my code
Part Number: MSP430F447 Other Parts Discussed in Thread: MSP-EXP430FR5994 hi
i want to access microsdcard which has bmp files . i want to display that in tft . do you have any sample code for that
with regards
senthil
Part Number: MSP430F447 Hi
i have drawn schematic and i have some unused pin should i have to connect to ground or to pull up , by doing so can i use it later if i want .
regards
senthil
Part Number: MSP430F447 hi
I am planning to interface I2C eeprom to microcontroller msp430f447 .I want to know how to design schematics.Because i don find SDA,SCL pins in the pindetails but the datasheet shows u can interface I2c devices to this processor…
Part Number: MSP430F447 Other Parts Discussed in Thread: L293 Hi
I am driving L293 Ic from Microcontroller.
while programming in Jtag i mean when my board is power on while flashing the code all the port pin connected to motor driver is high and makes…
Hi Senthil,
I am sorry to say that we actually don't have an application note or code examples for the lcd driver(ILI9341) you are using with.
But I have some suggestions which may help you on your design.
1.Read the datasheet of the lcd dirver…
Hello Uchida,
The FLL portion of the FLL+ module controls the main DCO tap and the modulator to combine two adjacent DCO frequencies. With the temperature drift, these DCO taps can vary by 10% typical. I believe you are right here in that at the lower…
