Part Number: MSP430F5435A Other Parts Discussed in Thread: MSP430F5418A , MSP430F5437A Are the MSP430F5435A, MSP430F5437A, and MSP430F5418A drop in compatible as long as Code Composer is set up to compile for the correct part? We are having supply chain…
Part Number: MSP430F5435A Other Parts Discussed in Thread: MSP430F5435 We are migrating a design from the MSP430f5435 to the MSP430f5435A variant and after reading slaa419c guide it looks like the other thing I have to worry about is setting up the Internal…
Part Number: MSP430F5435A Other Parts Discussed in Thread: MSP430F5435
Hi all,
Previous batches of our boards have come with RevE (and earlier) parts and our code has worked fine on those.
We've now had a new batch of boards built that have come…
Part Number: MSP430F5435A Hello,
I have Segment B corruption on around 50 Msp430F5435A (rev F and rev H). All the segments B are written with 0xFF. For these msp I have several SVSH and SVSL resets type. Do you know which could cause this corruption…
Part Number: MSP430F5435A I'm using RTC_A, clocked by REFO . In active mode CPU is clocked by XT2(11Mhz).
In Active mode, REFO (measured with scope on ACLK pin) is 32900Hz,
entering LPM3 causes ACLK to rise up to 33000Hz.
I tryed to keep settled…
Hi Derek,
I assume that you were able to find a fitting product as you didn't reply anymore, so I'll close this post.
Please feel free to comment again if you look for further assistance regarding this topic, it will re-open the thread. If you have…
Part Number: MSP430F5435A Other Parts Discussed in Thread: MSP-FET , CODECOMPOSER , UNIFLASH I am using Linux Mint 18.3 64 bit, and an MSP-FET.
I was using version 5.0.0.25 with the ia32 package installed (to provide 32 bit support).
After upgrading…
Other Parts Discussed in Thread: MSP430F5435A Hello, I have a question about the MSP430F5435a. When I have a reset of the MSP I read the SYSRSTIV register but sometimes I read the value "1Ch", but in the datasheet this value is linked to "Reserved". How…
See the USCI UART Calculator .
Anyway, these calculations assume that the clock is accurate to begin with. However, when using the DCO, the modulator switches between neighbouring frequencies and introduces jitter. If you want to minimize these additional…
