Part Number: MSP430F5510 Tool/software: Dear expert,
If the customer want to do their own PID/VID,
We are able to agree that without any contract, right?
Best Regards,
Eric Chen
Part Number: MSP430F5510 Other Parts Discussed in Thread: UNIFLASH , DRV2700EVM Hi, T.I.
I am trying to update the DRV2700EVM's firmware to the latest version, 1.7, using UniFlash.
But I keep getting the “No USB FET was found” error.
I…
Part Number: MSP430F5510 Other Parts Discussed in Thread: UNIFLASH , Hi. I am trying to use UniFlash to generate a checksum to compare the binary .out file with another checksum. Does Uniflash have a checksum utlity feature for the MSP430F5510? If not,…
Albert Abed said: Now, it seems that we can select any crystal with a desired frequency as long as it is within MSP430 allowable range 1.5 Mhz and 32 Mhz for USB operation and not to worry about the internal load capacitance inside MSP430.
Just note that…
Part Number: MSP430F5510 Hello,
I am trying to create a JTAG chain to flash Device A. Device A runs CC2642 and currently being flashed through JTAG using a 10-pin ARM Connector on SmartRF06 Evaluation Board. I am designing a new PCB (Device B) which will…
Part Number: MSP430F5529 Other Parts Discussed in Thread: MSP430WARE I have a question about MSP430F5529 Low Power. when I use MSP430F5529 enter Low Power 4.5 status,The MCU current flow is 10~22uA,why not is 0.1uA.
when MCU power is 3.3V ,The MCU Low…
Part Number: MSP430F5510
Hi Team,
Customer is debugging I2C operation of msp430F5510+MAX7311 and is currently using code from routine, " MSP430F550x_uscib0_i2c_08.c" . After the customer has configured the port, it now finds that the data cannot…
Part Number: MSP430F5510 Other Parts Discussed in Thread: MSP-GANG , UNIFLASH , MSP-FET Hi
May I have a question about write MSP430Fx 's flash memory?
My customer is using MSP430F5510.
And want to write data that data + code to 2 section (information…
Part Number: MSP430F5510 Other Parts Discussed in Thread: MSP430WARE , Hi experts,
I would like to confirm about the software for MSP430 USB.
Q1: Are the following information all the interrupts that may occur during normal operation except RESET in USB…
Part Number: MSP430F5510 hi, I am trying to Communicate with the ADC through SPI and Bluetooth with a UART.
but I received a "cannot load from non-primitive location" type of Error in Tx And Rx Buffer. Also Attached the image of the same
