Part Number: MSP430F5658 Tool/software: Hi team,
We are planning to use the MSP430F5658IPZ microcontroller in one of our designs. We intend to utilize the USB2.0 interface present in the MSP430F5658IPZ to connect directly with the processor(For chip…
Part Number: MSP430F5658 Other Parts Discussed in Thread: MSP430F5659 Hi
I know this sounds like it should be a customer support request, but I tried that and they can't help.
The situation is that I designed a product using the MSP430F5659ipz that…
Part Number: MSP430F5658 Other Parts Discussed in Thread: MSP430F5659
I'm doing multichannel continuous sampling of 60Hz signal on 8 channels, when i power up the system everything is ok and results are exactly as expected.
when i turn off the mains…
Part Number: MSP430F5658 I'm building and device that require to sample 3 phase current, i'm using two ADC channels to sample every phase (total 8 channels) if the high gain channel get saturated i use the low gain channel.
The problem the ADC reading…
Hello Nilton,
It may be possible but it may take a lot of edits to the firmware code and may end up being impossible.
I will check with someone else on the team to see their opinion.
Sincerely,
Wyatt Keller
Part Number: MSP430F5658 During product ESD testing a condition was found where the processor would not respond to a reset. It would however respond to connecting the IAR IED and FET430UIF interface, selecting "attach to running project" selecting break…
Part Number: MSP430F5658 using the MPS430F5658 we are using the sample MSP430USBDevelopersPackage_5_20_06_02 code to emulate a SD drive. The transfers are very slow with a typical rate of 330 KB/sec. During a test early on in the project it was up to…
Hello,
Please let me know when I should power up DVCC after PUR high (for USB BSL). On my customer's board, the time between the PUR high and the powering up of DVCC is 5 seconds, and then BSL doesn't run normally.
Best Regards,
Nomoto
