Part Number: MSP430F6779 Other Parts Discussed in Thread: UNIFLASH I developed an energy meter based on MSP430F6779. UniFlash refuses to program it with some code of the reference board based on the MSP430F6779I. IAR Workbench can program the code but…
Part Number: MSP430F6779 Other Parts Discussed in Thread: TRF7970A
Hi,
I got the example code for TRF7970A with MSP430F5529LP board, but I need to initialize the RFID-TRF7970A with Different board that is MSP430F6779,
which is embedded on 3-phase energy…
Hello,
As target(MSP430F6779) gets connected to EMDC software via UART and we receive data in EMDC software. so we tap RX and TX pin and connect it to FTDI to TTL converter to get packets that EMDC send to Target and Target sends to EMDC
We have made…
Part Number: MSP430F6779 Hello,
I am currently evaluating the MSP430F67 platform for a 3 Phase + N Rogowski current sensor application. In the Energy Measurement Design Center I can only create a phase if there is a voltage measurement channel. I am wondering…
Part Number: TRF7970A Other Parts Discussed in Thread: MSP430F6779 , Hi there,
I am trying to Read the Data using MSP430F6779 controller by using TRF7970A NFC.
Is there any Documents or sample code related to NFC with MSP430F6779 Microcontroller.
Part Number: MSP430F6779 I am trying the echo example i am able transmit but not able receive. The RX interrupt fag is not getting high to trigger interrupt /* --COPYRIGHT--,BSD
* Copyright (c) 2017, Texas Instruments Incorporated
* All rights reserved…
Here is the source code under this link: https://www.ti.com.cn/cn/lit/an/slaa577g/slaa577g.pdf?ts=1692925724885
The E-meter code in this doc is an old version. I would suggest you refer to the EMDC.
Part Number: MSP430F6779 I have a custom PCB board that we designed with an MSP430F6779 processor on it. I am able to program the chip successfully.
When I power the board without the JTAG programmer connected, the chip won't boot up and run code. When…
If so, my quesiton is that in release mode, the UART will send nothing?
Can you add a gpio toggle into the UART receive code and check under release mode?