Part Number: MSP430FR2633 Hello ,
I am using MSP430FR266 for our capacitive touch keypad application which has 16 touch button using mutual capacitance. Currently , it works perfectly fine when the user touches keys softly, but whenever the touch is…
Part Number: MSP430FR2633
Hi,
I want to get Source code for CAPT_calibrateSensor function and other rom funtions in the cative touch library provided by Ti.
Where will I get these source code.
Part Number: MSP430FR2633 Other Parts Discussed in Thread: MSP-FET , I need to use all GPIO pins from MSP430FR2633. That means I need to share jtag with gpio pins. According to the datasheet, Test pin should set high to enable jtag and pulled down to GND…
Part Number: MSP430FR2633 I setup TI Capacitive Design Center with desired configuration and generated the code. Then I imported the code in Code Composer Studio, it shows this error. Any help will be greatly appreciated.
See details below... Import…
Part Number: MSP430FR2633 Hello,
The datasheet for the MSP430FR2633 mentions that captivate pins have both internal pull up and pull down resistors and at startup are in a high impedance state. Does this mean that they're configured on startup as an input…
Part Number: MSP430FR2633 I am prototyping an MVP using MSP430FR2633 as a proximity sensor. I didn't see anything about adjusting sensitivity with software in the datasheet and reference manual. I would greatly appreciate it if someone could give me some…
Part Number: MSP430FR2633 Hi,
Several CAPTIvate metal switches (1 cm to 1.5 cm wide) are lined up on the prototype board.
However, probably because the button width is close, it responds no matter which switch I press.
If you have any advice on countermeasures…
Part Number: MSP430FR2633 Hi,
My customer is adjusting the RX/TX resolution of the touchpad with the CapTIvate Design Center GUI. I have two questions about this.
Q1) "Desired Resolution X Axis" and "Desired Resolution Y Axis" are described as "The desired…
Part Number: MSP430FR2633 Hi team,
Here's an issue from the customer may need your help:
Project generated by CapTIvateDesignCenter. The goal is accomplish LIN communication by using UART(Auto baud rate mode).
This customer need to complete initializing…