• 

  rei

  • over 1 year ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  MSP430FR5720: Sleep time measurement using RTC calender

  TI Thinks Resolved

  Part Number: MSP430FR5720 Hi, I hope to check the time elapsed since sleep using the calendar function of MSP430FR5720. For example, if I set the calendar for one day and wake up from GPIO after 10 hours, can I get the value of 14 hours from the RTC...
• 

  Elisha Tarroza71

  • over 1 year ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  MSP430FR5720: Alpha Particle Hardness Test Results

  • Resolved

  Part Number: MSP430FR5720 Hello, Customer has read through this document and is requesting for any
• 

  HS WG-FAE

  • over 1 year ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  RE: MSP430FR2153: I2S interface

  Hello Bruce, so, you say with a device like MSP430FR5720 which has a DMA it should work? Regards, Holger
• 

  Koichiro Tashiro

  • over 3 years ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  MSP430FR5720: Part of FRAM cleared to 0x00

  TI Thinks Resolved

  Part Number: MSP430FR5720 Hi, My customer is using MSP430FR5720 and encountered an issue. The system suddenly stops working after power cycle and customer found part of code memory is cleared to 0x00. The issue was observed with 3pcs (in 60pcs total)...
• 

  ran zhang1

  • over 7 years ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  please help! msp430fr5729 consumes >100uA in LPM3 mode

  I'm debugging a firmware provided by a customer claiming there is current leak while the system is in sleep mode, to eliminate this is caused by the peripherals on the board, electrically all the components on the boards are removed, only thing left...
• 

  Serguei Bezroukov

  • over 8 years ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  XT1 MSP430FR5720 problem

  • Resolved

  on MSP430FR5720 . It just does not start. The scope attached to the ACLK monitoring pin shows the VLFO frequency
• 

  Jason Work

  • over 7 years ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  RE: pin combatibility

  Mike Dalby Do you know if there is an alternative pin compatible MSP430 (lower cost) solution to an MSP430FR5729 (VQFN-40)..... I understand that I can drop down to the MSP430FR5720 but wondered if there is anything even cheaper in a traditional memory...
• 

  mpgorans

  • over 7 years ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  Cycle between power states continuously?

  Disclosure: not very experienced, so keep that in mind when reading/replying I am currently using an MSP430FR5720 in my system. What I would like to do is cycle between an ON state and LPM. Say, 100ms ON, 400ms LPM; something similar to that. While...
• 

  Mike Pridgen

  • over 7 years ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  RE: MSP430FR5739 GPIO errata

  Hans, The smallest package in the MSP430FR5739 family (MSP430FR57xx) is the MSP430FR5720 in the 24pin RGE package. The pinout for this package is shown on page 9 of the MSP430FR57xx datasheet . Any pin listed in this pinout is NOT affected by Erratum...
• 

  Tim Reyes

  • over 7 years ago
  • MSP low-power microcontrollers
  • MSP low-power microcontroller forum

  FR5720 Bootstrap Loader Question

  • Resolved

  ? The MSP430FR5720 has a bootstrap loader and I need to provide optimum security for the device firmware. I know

Didn't find what you are looking for? Post a new question.

• Ask a new question