Search tips
Showing 44 results View by: Thread Post Sort by

  • MSP430FR5728: Fault Monitoring for Overhead Fault Indicators

    Part Number: MSP430FR5728 Tool/software: Hi Sir: How can we design 10KV voltage detector at Fault Monitoring for Overhead Fault Indicators? BR SH

  • MSP430FR5728: Programming before reflow or hand soldering

    Part Number: MSP430FR5728 Tool/software: According to MSP430FR5728 datasheet, page 14, note 5, "Programming of devices with user application code should only be performed after reflow or hand soldering". What happens if the programming is done before…

  • MSP430FR5728: Internal function to introduce delay or check the time elapsed

    Part Number: MSP430FR5728 Hi Team, I am developing an application first time based on MSP430FR5728. I have a few questions related to the I/O interrupt, Timer and delays. In the application, I need to monitor the interrupt for 5 sec and reset my variables…

  • MSP430FR5728: How to check if data available in FRAM after reset

    TI Thinks Resolved
    Part Number: MSP430FR5728 Hi Team, I am developing an application for customer based on MSP430FR5728. In the application, counter data are stored in FRAM in the normal operation. After Reset, before initialising all peripherals again I need to know if…

  • CCS/MSP430FR5728: Ez-FET lite burn fails, Bootloader issue?

    TI Thinks Resolved
    Part Number: MSP430FR5728 Other Parts Discussed in Thread: MSP430F5529 Tool/software: Code Composer Studio Hi E2E, I have ordered a PCB with MSP430FR5728_RGE on it. I am trying to burn it with MSP430F5529 Lanuch pad. I followed the instructions and managed…

  • CCS/MSP430FR5728: strange debug behavior for FRAM section when single stepping

    TI Thinks Resolved
    Part Number: MSP430FR5728 Tool/software: Code Composer Studio When I put a breakpoint after the deliberate infinite while loop in the program below, and I run the code (simplification from a bigger project) in the debugger, then it, correctly, stays…
    • Answered

  • MSP430FR5728: Low temperature out of spec usage

    Resolved
    Part Number: MSP430FR5728 I am investigating using an MSP430FR type device with a small package at very low temperatures. The FRAM is of particular interest. I found that the MSP430FR5728 will continue running when it is submerged in LN, -196C, but then…
    • Resolved
    • Answered

  • CCS/MSP-FET430UIF: MSP430FR5728

    Resolved
    Part Number: MSP-FET430UIF Tool/software: Code Composer Studio Hi, I have question concerning the recommended connection of the /RST/NMI input of the MSP430FR5728. Refering page 40 of SLAU272C there is a pullup resistor of 47K to Vcc and a pull-down capacitor…
    • Resolved
    • Answered

  • Compiler/MSP430FR5728: the availability of doubling I2C channels ?

    Resolved
    Part Number: MSP430FR5728 Tool/software: TI C/C++ Compiler In the Msp430fr572x family user's manual, page 530, mentions in blue : The eUSCI_B module supports two serial communication modes: • I2C mode • SPI mode If more than one eUSCI_B module…
    • Resolved

  • CCS/MSP430FR5728: programming issue

    Part Number: MSP430FR5728 Tool/software: Code Composer Studio hi sir I am getting following error while running my code "../lnk_msp430fr5728.cmd", line 130: error #10099-D: program will not fit into available memory. placement with alignment fails for…

Didn't find what you are looking for? Post a new question.