Part Number: MSP430FR5887 After generating code using FlowESIGUI, I found that it did not calibrate well during runtime. Upon reviewing the code, I discovered that VALID_RECALIBRATION and RECALIBRATION_TIMEOUT were not cleared. The consequences of not…
Part Number: MSP430FR5887
Hello E2E Experts,
The sensor uses MSP430FR5887 as the main controller. Production process: firmware burning - parameter calibration (parameters are stored in FRAM) - power off - power on - sensor high-temperature counting…
Part Number: MSP430FR5887 The ESI module is supposed to operate in a -20 degrees Celsius environment, but the test failed and the counting stopped. How can we improve this?
Additionally, if the calibration is performed using AFE2, it is impossible to…
remove the ESD, we get the same result. The final voltage is betwen 1.7V and 1.8V.
Is there any method to check the inner circuit of Reset pin of MSP430FR5887?
Part Number: MSP430FR5887 How to enhance the detection distance of ESI module to metal? What aspects should we start from?Which parameters to modify in the code
Hi,
yes there are limits based on the scan rate that is determined by the SW. For the regular SW that comes with the EVM I had good results with 2-4 rotations/sec.
Part Number: MSP430FR5887 Dear all：
I used MSP430FR5887 to design the magnet-free sensor. When my program was just written, I ran sample OK.But then the power went off and the sampling went haywire.
The power supply is 3V, I use the voltage regulator…
Part Number: MSP430FR5887 Tool/software: Code Composer Studio Many manufacturers without magnetic sensor in the factory on the inductance surface affixed metal film, and some manufacturers did not stick.Does this metal membrane do anything?
