Search tips
Showing 1,151 results View by: Thread Post Sort by

  • MSP430FR6047: LCD_C external voltage restrictions

    Part Number: MSP430FR6047 Tool/software: Is it possible to use 2.8V VCC and 3.3V on Pin LCDCAP for VLCD? Thanks!

  • MSP430FR6047: MSP430FR6047 unused pin configuration for low power

    TI Thinks Resolved
    Part Number: MSP430FR6047 Tool/software: Dear Team, For my customer's application using as little power as possible is crucial. They noticed that for one of the unused GPIO pins, namely Port 1 / Pin 4, they currently have it configured as output high…

  • MSP430FR6047: bubble detection

    TI Thinks Resolved
    Part Number: MSP430FR6047 Tool/software: hi, when i run this demo software "MSP430FR6047EVM_USS_Water_Demo", in debugger mode, the API " code = USS_runAlgorithmsFixedPoint (& gUssSWConfig ,&algResFixed); " returns the error code as below when water…

  • MSP430FR6047: MCU018

    Part Number: MSP430FR6047 Tool/software: Hi, Is it correct MSP430FR6047 SDHS He is saying that don't increase ADC counts above 1000 for SDHS. Why? Thanks, Anup Kumar

  • MSP430FR6047: MCU018

    Part Number: MSP430FR6047 Tool/software: Hi, I am using the TI board with MSP430FR6047 and with flow tube connected to it. The issue is when reference meter is reading constant flow rate say for example 500LPH or 0LPH. TI board is reading 480 LPH fine…

  • MSP430FR6047: interrupt callbackfunction

    TI Thinks Resolved
    Part Number: MSP430FR6047 Tool/software: hi, :"MSP430FR6047EVM_USS_Water_Demo" i am using this driver package, in this driver where is gpio interrupt callback function? thank you Chandrasekaran V
    • Answered

  • MSP430FR6047: Device may enter lockup state during transition from AM to LPM2/3/4 stated in errata of MSP430FR6047.

    Resolved
    Part Number: MSP430FR6047 Tool/software: In my application, the main code starts and then enters LPM3 mode . The application exits LPM3 under the following conditions: An interrupt occurs every 15.625 ms , and its ISR is served without exiting LPM3…
    • Resolved
    • Answered

  • MSP430FR6047: MCU018

    Resolved
    Part Number: MSP430FR6047 Tool/software: Hi, What If I enables #ifdef USS_APP_AGC_CALIBRATE_ENABLE in code. where it can impact my calculation of time of flight? Regards, Anup Kumar
    • Resolved

  • MSP430FR6047: ADC Saturation

    Part Number: MSP430FR6047 Tool/software: If the differential voltage at pga input goes beyond 800mV or 1000mv and if the Adc goes into saturation mode can these two phenomena cause phase shift in upstream and downstream tof at zero flow. Also , we belive…

  • MSP430FR6047: Unrealistic high flow rate measurements

    Part Number: MSP430FR6047 Hello, We have a water flowmeter that we developed using the MSP430FR6047, we have deployed this flowmeter in the field. We have noticed over the last week that the flowmeter will occasionally report very high flow rates…

Didn't find what you are looking for? Post a new question.