1) I don't see where you call InitI2C()
2) Sooner or later you need to do a "PM5CTL0 &= ~LOCKLPM5;"
3) A 1000-cycle delay (at 1MHz) is 1ms, not Twr=5ms.
4) > I2C_Master_WriteReg(0x50, 0x05,5555,4);
According to your earlier post,…
Part Number: MSP430FR6928 Other Parts Discussed in Thread: LM35
I'm trying to use the temperature provided by the internal sensor of the MSP430FR6928. I followed the recommendations shown in one "Out of the Box" application for a similar device.…
It was a typo ... the name is fram_ro_start ... This is a capture from a training on FRAM named MSP430 workshop ... about 14 minutes into the video.
www.ti.com/.../msp430-workshop.html
It looks as if the values that you enter in the GUI reach to the…
Part Number: MSP430FR6928 Other Parts Discussed in Thread: MSP430FR6989 Hi,unable to generate the I2C interrupt while interfacing with at24c256 eeprom.
i refer the below code:
//*************************************************************************…
Part Number: MSP430FR6928 Hi,we are interfacing the seven sengment display GDC570 to MSP430Fr6928 but its not displaying the accurate digit.please help us to display the accurate digit on seven segment display .We configured seven sengment display as…
Part Number: MSP430FR6928 Hi,we are interfacing the seven segment display GDC0570 to MSP430FR628 but its not displaying the accurate digit.please help us to display the accurate digit on seven segment display .we configured seven segment display as follows…
Part Number: MSP430FR6928 Referring to paragraph 35.2.6, the User Manual for the MSP430FR6928 states:
The voltage reference generator can generate a fraction of the device VCC or of the voltage reference of the integrated precision voltage reference source…
Part Number: MSP430FR6928 According to the manual:
The UCTXIFG interrupt flag is set by the transmitter to indicate that UCAxTXBUF is ready to accept another character. An interrupt request is generated if UCTXIE and GIE are also set. UCTXIFG is automatically…
Part Number: MSP430FR6928 I want to read the main memory from MSP. I use MSP430Flasher.exe. I write the command and then run. I read main memory but It's not in the format I want.
my command :
MSP430Flasher.exe -v -n MSP430FR6928 -r [out.hex,MAIN] …
Part Number: MSP430FR6928 Hi,
I need more ram space for a project. I applied the methodology that is described in document “slaa628b.pdf” however somethings is wrong.
RAM2 is defined in linker like below;
MEMORY
{
TINYRAM : origin = 0x0006…