Part Number: MSP430G2252-DIE
Dear Texas Instruments Team,
Thank you for your support.
I have a question for part MSP430G2252TDA1.
The customer would like to know how to connect the chip to the board?
By wire bonding
or
By flip chip bonding…
Part Number: MSP-EXP430G2 Other Parts Discussed in Thread: ENERGIA , MSP430G2553 , MSP430G2252 , MSP430G2452 Hello,
I have a G2 LP that had an MSP430G2553 installed. I have no issues programming the onboard 2553 with both CCS (latest version) and…
Part Number: MSP430G2252 Other Parts Discussed in Thread: HDC1080 , MSP430WARE , MSP430G2121 I'm looking to migrate a customer from an Atmel based application to one of our processors.
First I need help selecting the right processor. I have pre-selected…
hello
First let me say that i have looked through the data sheet, and tried to search how to do 200ksps but have been unsuccessful in finding
1.Formula for calculating the samples per second with example
2.I need sample program to do adc at 200ksps…
Other Parts Discussed in Thread: MSP430G2252 Hi all, I'm working on MSP430G2252 to configure an I2C slave. I can't avoid that SCL line is held low by my slave : that cause a later answer of my slave
I tried different options but none works. Here below…
Other Parts Discussed in Thread: MSP-TS430PW28A , MSP430G2252
I'm using a MSP430G2252 with a MSP-TS430PW28A and a MSP-FET430UIF. No matter what I try, I never get a high signal from P2.6 or P2.7. According to the data sheet, I have to set P2SEL…
Other Parts Discussed in Thread: MSP430G2252 Hello
I'm working on a little projects, I started out with A 2452 (8k), but after optimization to code was under 1950bytes, so i put in a 2252 (2k).
when i tried to build it i get this error: (using up…
Part Number: MSP430G2211 Other Parts Discussed in Thread: MSP-EXP430G2ET , , MSP430G2252 Using IAR IDE and MSP-EXP430G2ET when downloading code that makes properly I get "cannot reach main" error. Single-stepping shows in downloading (not in my code)…
Other Parts Discussed in Thread: MSP430G2252 Hello
Is it possible to sample 4khz frequency in adc using controller msp430g2252.If it is possible means pls suggest some answers
Other Parts Discussed in Thread: MSP430G2252 I have a C program for IR communication using MSP430G2252, but I am using G2553 in my project. Then what are the differences in need to do in prgramming? What are the basic differences between these two ICs…
