Other Parts Discussed in Thread: MSP430G2302 , CC115L Hi,
What is the simplest way to create a unique identifier during production for a product that includes CC115L + MSP430G2302?
Is there a Die ID, wafer number, X/Y location, Mac_address or some other…
Other Parts Discussed in Thread: MSP430G2302 Hello,
Is there a way to configure MSP430G3203 to use slow clock 32-kHz based without crystal, based on internal counters (while going to LPM3). In we are looking for a low cost + low power solution.
Regards…
Avi,
Avi W said: We use MSP430G3202, when entering LPM3 and receiving interrupt from timer.
I'm assuming you're using the MSP430G2302 here.
Avi W said: As I understood without setting the SR with LPM3_EXIT we will be inside the LPM3 right? [although…
Other Parts Discussed in Thread: MSP-GANG , MSP430G2302 , MSP430G2452 , MSP430F2013 , MSP-TS430PW28A , MSP430F2001 , MSP430F5419A Hi,
GANG430 hardware had a limitation that the Devices programmed in 2-wire mode does not run after programming.
Is there any plans…
Other Parts Discussed in Thread: MSP430G2302 Hi,
Can we connect an external sinusoidal clock source directly to MSP430G2302, rather connecting a crystal to both XIN and XOUT pins?
The clock signal is not square and have peak-to-peak difference of 3.3V…
John Mielke said:
Is there any design example of G series device, preferable MSP430G2302? We are reviewing the schematics and it would be best to have an official example to look at side-by-side.
Try the MSP430 LaunchPad. For the MSP430G2302, I suggest…
Matt Shira said:
... the board has its own 1.8V power supply...
I would caution against powering your MSP430G2302 with 1.8 V for a few reasons:
Tolerance. What is the tolerance of your 1.8 V supply? 1.8 V is the minimum supply voltage for the MSP430 …
Other Parts Discussed in Thread: MSP430G2302 Hi,
My MSP430 board uses a MSP430G2302 chip. The package is RSA with 0.65mm pitch. After repeatedly using probe to test pin 1, 2, 3 and 4 signals, I found that pin 2 and 3 can no longer be driven to desired…
Jens,
Here is the definitions of LPMs from TI’s msp430g2302.h:
TI msp430g2302.h said:
/************************************************************
* STATUS REGISTER BITS
************************************************************/
#define C (0x0001…
Other Parts Discussed in Thread: MSP430G2302 I made my own capactive touch PCB board. And I found a problem when debugging RO_PINOSC_TA0_One_Button_Compact project (I have changed configuration according to my own board's situation).
The problem is…