Search tips
Showing 24 results View by: Thread Post Sort by

  • MSP430G2303: Maximum current peak during transition to low power mode

    Part Number: MSP430G2303 Hi, we have a MSP430G2303 which can switch to LPM3 mode if main CPU is off. During the change from normal to low power mode there is a peak on the current consumption. Are the any measurements done by TI which value of current…
    • Answered

  • RE: MSP430G2303 LaunchPad, Energia ERROR 0451:f432

    Resolved
    This is because of the different Energia versions, as stated before I am using E17. However the fact that you are using a MSP430G2303 could be the issue as I am using a G2553 on my setup and believe that only the G2231, G2452, and G2553 variants are supported…

  • RE: BSL and SPI collision in MSP430G2303 CC1101 BBased Design

    Have you tried if the BSL works without the CC1101 connected? UCB0CLK is an output of the micro since the MSP is the master. So for your CC1101 it is an input - that means the CC1101 will not change it's level or holding it at either 0 or 1. If you do…

  • Bootstrap Loader Version in the MSP430G2303 ?

    Other Parts Discussed in Thread: MSP430G2303 Does anyone know the version of the BSL in the MSP430G2303 device ? It seems there are quite a few differences in the bootstrap loader, so vould like to know which version is in this device. Thanks in advance…
    • Answered

  • MSP430 production programming

    Resolved
    Other Parts Discussed in Thread: MSP430G2232 , MSP430G2303 , MSP430-FLASHER , MSP-FET I am aware of the MSP-GANG tool. What additional production programming solutions do we have available to do batch programming of MSP430G2303, MSP430G2232, etc.? …
    • Resolved
    • Answered

  • RE: MSP430F67751A: programming via JTAG interface

    Resolved
    Hi, thanks for response. Are you sure? Now I am using package slau320w\Replicator430 for MSP430G2303 programming and when I try to get MSP430F67751A processor ID from address 0x1A04 in the same order as for MSP430G2303 from address 0x0FF0, the response…
    • Answered

  • RE: Thermal characteristic of MSP430G2303IRHB32

    Resolved
    Hello Harsha, I am currently pulling in a reliability expert to provide the thermal resistance of the MSP430G2303 VQFN RHB package. Regards, Ryan

  • RE: CCS/MSP430G2201: MSP430G2201

    Jayant, The eZ430 is the FET on-board the LaunchPad which you are using to program the MSP430G2303, using firmware initialized for a MSP430G2553. Regards, Ryan
    • Answered

  • MSP-GANG Problemmer can't program msp430Gxxx

    Resolved
    Other Parts Discussed in Thread: MSP430G2303 Hi everyone: I am using msp-gang to program the mcu. When I program msp430F2312, it's successful for everything, erase, blank check and program. But when I program for msp403g2303, it can be erase, blank…
    • Resolved

  • Flashing two images on the same controller

    Other Parts Discussed in Thread: MSP430G2303 Hi , Following is a breif introduction about the problem I am facing, Iinitially I was planning to use the msp430f5xx controller in my project, and I had planned to have 1 custom BSL(which is responsible…

Didn't find what you are looking for? Post a new question.