Other Parts Discussed in Thread: MSP430G2452 I can not seem to have the SCLK signal held low when operating in the slave I2C mode. The I2C communications run fine, but I need to introduce a SCLK clock stretch when 'reading/writing' data. After de…
Pardon me,
I see you are using the MSP430G2402 with Launchpad.
I am unable to program the chip
Writing Memory Block ... not supported by this driver
Any pointers would be greatly appreciated
http://e2e.ti.com/support/microcontrollers/msp43016-bit_ultra…
Other Parts Discussed in Thread: MSP430G2231 , MSP430G2402 , MSP430G2211 I've read several other threads with similar messages.
I've run "3583.LaunchPadFirmwareUpdater.zip" (result: no update required).
Launchpad programs/runs/debugs…
Part Number: BQ28Z610 Other Parts Discussed in Thread: MSP430G2402 Hello, I use the BQ28z610 + MSP430G2402 on my board, Now I want to unlock the password and read the revision, ID of battery. But the information which I read aren't consistency, I don't…
Part Number: CC110L Other Parts Discussed in Thread: MSP430G2402 Hi TI,
We are designing a low cost battery powered tag using the CC110L and MSP430G2402. Can TI review the design ? If so, where do I send the schematic + layout files ?
Thx
Kris
Part Number: BQ76930 Other Parts Discussed in Thread: MSP430G2402
Hi greeting
I'm helping my one of customer to debug the bq76930 + MSP430G2402 , applicaion
application with 10 cell the first version schematic as attachment,
and their design was…
Hi Dennis
thank you for your prompt Reply
we use the MSP from long time approxmatly 15 year.
we Always had this problem on all controller that we used example
Msp430F435, Msp430F135, Msp430F133,Msp430g2955,Msp430g2553,Msp430Fr5972,Msp430g2402 etc..
we…
I never used the part you are using at the moment, but in general you can establish a UART connection based on the timer module. The examples I linked in are from a processor that does not have a UART as well (MSP430G2402). I don't know about the available…
Other Parts Discussed in Thread: MSP430G2402 , MSP430-FLASHER Using a launchpad as the programmer, using the TEST and RESET pins to the target board, the command line works great for programming and reading back but erase, JTAG disable and BSL (password…
Other Parts Discussed in Thread: MSP-GANG , MSP430G2402 I'm using MSP430G2402 MCU and MSP-Gang.dll to program it. I can program it using the DLL, but how do I verify that the programming is correct (eg perform verify / read checksum)?
I tried to use…