Part Number: MSPM0G3107 Tool/software: Hello,
I am trying to configure the PORT module for MSPM0G3107 in Tresos . I am using the mcal package MCAL_MSPM0G350x_00.01.03.00, as I was informed that it is compatible with our board.
I want to disable PortSetPinDirectionApi…
i custom my MSPM0G3107 and put direct my BSL into pins i need here is my custom card :
should i put a resistor or capacitor or quartz for flashig my code ?
Matze thanks mate for your help i try it but nothing, i think my MSP are dead i will retry with…
Part Number: MSPM0G3107 Tool/software: We are trying to configure the PORT module for MSPM0G3107 in Tresos . We are using the mcal package MCAL_MSPM0G350x_00.01.03.00, as we were informed that it is compatible with our board.
Can you please tell me how is…
Part Number: MSPM0G3107
Tool/software:
Hi team,
①What are the performance/functional limitations when operating at VDD = 1.8 V or 2.5 V (in the range of 1.62 V to 2.7 V)?
②The test condition for p.37 (7.17 SPI) on mspm0g3107.pdf data sheet stated that…
Part Number: MSPM0G3107 Tool/software: Hi TI teams,
I want to confirm the issue regarding pinout.
I would like to ask if the pinout of MSPM0L, MSPM0G, MSPM0C series is the same when they are in the same package?
Thanks, Steve.
Part Number: MSPM0G3107 Other Parts Discussed in Thread: SYSCONFIG Tool/software: We wish to route one ADC pin to PA22 (pin 18 on VSSOP20), but this is apparently not allowed in the System Configuration tool. The datasheet implies the pin should be available…
Hi, Kenley
Kenley said: In that case, I think it is necessary to cancel the reset once, but when should they do it?
It's related to Vdd level, once VDD is > POR, NRST can set to high to let M0 run BOR and boot code.
For the LP-MSPM0G3507, you can…
Part Number: MSPM0G3107 Tool/software: Hi team,
There is an explanation about starting a program with BSL (Bootstrap Loader) at data sheet mspm0g3107.pdf.
8.29 Bootstrap Loader (BSL)
Does BSL start when one of the following three conditions is met?…
Thanks Yuhao.
I missed that "pull-down" menu :-). I often have an issue finding options with the invisible menu's. Maybe TI would improve the config section.
Thanks
Part Number: MSPM0G3107-Q1 Tool/software: Hi,
The code has other I2C subroutines that work, but for some reason the I2C interrupts are not happening and the IRQ Handler is not entered from this subroutine.
Any ideas?
Thanks,
Dave
ps. subroutine below…