Part Number: MSPM0L1228 Tool/software: Hi,
In my company we are developing a project having M0L1228 microcontroller. I have a question regarding SWD port protection: considering that we want to follow SWD Security Level 1, in which memory register the…
Part Number: MSPM0L1228 Other Parts Discussed in Thread: MSP430F5437A , , SYSCONFIG Tool/software: Hi,
one of our legacy device is using MSP430F5437A. it was using CCSv4 compiler on Windows 7. we have not used any tool to generate the drivers and manually…
Part Number: MSPM0L1228 Tool/software: Hi sir,
I followed
https://dev.ti.com/tirex/explore/node?node=A__AMR3wfadnWEvP9nuKCCQdw__MSPM0-SDK__a3PaaoK__LATEST to implement MCU temperature function. But I found I can just get around 25.X degC even I heat it…
Part Number: MSPM0L1228 Tool/software: Hi sir,
We encountered one issue about RST_N pin in our new arrived board.
For the first boot, if we pull RST_N low and then high. the MCU can boot-up to run my app code successfully. After the MCU is up, if I still…
Part Number: MSPM0L1228
Tool/software:
Hi sir,
We need 2 ADC channels for reading MCU temperature and AIN. But I can just create one ADC12 instance. Could you help tell me how to configure?
Thanks,
Edware
Part Number: MSPM0L1228 Tool/software: Hi sir,
We have a capacitor on our board and we need to enable super capacitor charge. But it will crash after calling DL_SYSCTL_enableSuperCapacitor(). Is there any procedure need to do before enabling it?
Thanks…
Pengfei,
for below, it means that customer can set reset pin low but need to make sure VBAT voltage high enough.
Pengfei Xie said: What is the impact/concern for customer's application of current situation? (after adding NMI handler)
for below, you…
Part Number: MSPM0L1228-Q1 Tool/software: Dear Expert
For the 5V-tolerant open drain IO type does not have the output-high PMOS, pullup resistor, or clamping diode .
But it has a pull-down resistor and an NMOS .
I use ODIO as the TXD pin to connect to…
Part Number: MSPM0L1228 Tool/software: Hi sir,
We are using DL_SYSCTL_enableSuperCapacitor() to charge our external large capacity but it's slow. Is there any way to adjust the charging current limit?
Thanks,
Edware
Part Number: MSPM0L1228 Tool/software: Hi,
My customer has a question about data in Flash after Erasing.
What is read immediately after sector Erase without Program ?
Is the values before Erase read ?
There is the following note at the chapter 6.3…
