Part Number: OMAP-L138 Other Parts Discussed in Thread: TMS320C6748 Tool/software: Hi, TI expert
We have a question from a customer about OMAP-L138.
The customer is considering changing from DSP(TMS320C6748) to OMAP-L138.
There may be a current…
Part Number: OMAP-L138 Tool/software: When using NAND Flash boot mode, does the OMAP-L138 ROM bootloader use any form of an Error Correction Code (ECC) mechanism?
Can the OMAP-L138 ROM bootloader enable the ECC feature on the EMIFA?
Can the OMAP-L138…
Part Number: OMAP-L138 Other Parts Discussed in Thread: OMAP-L137 Tool/software: HI,
I just bought a SECOND OMAP-L138 LCDK board because I thought I had made mistake when I started the board (I left the dip switches to "00000000"). Try to follow the…
This is a bit of a legacy device so we are limited in terms what we can support here.
Naseer s said: Recently I found this error ,when i was trying to load my program in to DDR .
Sounds like the exact same process worked before? If so, you'd want…
Part Number: OMAP-L138 Other Parts Discussed in Thread: OMAP-L132 Hi.
We have been using the OMAP-L128 for many years. We are currently facing a lot of problems related to the NAND memories obsolescence. In the past, we validated NAND memories from…
Part Number: OMAP-L138 Tool/software: If the RESET pin is left unconnected, will the L138 fail to operate? Now CCS will report error connecting to the target. The JTAG test is successful.The power and clock seem OK. But the RESET(K14) is float. Is it…
Part Number: OMAP-L138 I am trying to control GPIO1[3] and GPIO1[4] using the Multiplexing Control 4 Register (PINMUX4) . The relevant pin functions are as follows:
SPI1_SCS[5] / UART2_RXD / I2C1_SCL / GP1[3]
SPI1_SCS[4] / UART2_TXD / I2C1_SDA…
Part Number: OMAP-L138 Tool/software: Hi team,
In the Errata Section 2.1.4, it is mentioned that the VDD filter ferrite beads and capacitor should be placed as the figure below into the clock source.
Question 1: Should C1 be placed before the beads…
