Search tips
Showing 7,318 results View by: Thread Post Sort by
    Answered

  • TPS65251

    Resolved
    Other Parts Discussed in Thread: TPS65251 , AM1808 , TPS65250 Questions about the TPS65251 datasheet: On Page 13 (Overview) it says, “The device has two built-in LDO regulators. During a standby mode, the 3.3-V LDO and the 6.5-V LDO can be used…
    • Resolved

  • How can I know whether a disk is inserted to the usb host on 6748 evm

    Dear senior engineer: My development hardware is the 6748 evm. I am using biosusb by rtfs to access the usb host. I need a function that can check whether a disk is inserted to the usb host as soon as possible. From the rtfs example I am using the…

  • Running the C6748 DSP on OMAP-L138EVM to run at 456MHz

    Hi, We need to run the C6748 DSP at 456 MHZ even though it is set up to run at 375 MHz. Can I get some guidance or documents on how to do this? Thanks, Scott

  • CCS/SECDEVTOOL-OMAPL138C6748: omapL138 LCDK: Will Not Generate Sine Wave

    Part Number: SECDEVTOOL-OMAPL138C6748 Other Parts Discussed in Thread: OMAPL138 Tool/software: Code Composer Studio I teach a class using the OMAPL138/C6748 LCDK. From time to time over several years, a problem crops up for a while and then goes away…

  • Setup bulk enpoint

    Hello, I am working on writing a driver for the peripheral side of the USB: * I am not using Linux * Using Full Speed * I am not using DMA * I am able to enumerate the device, show it in Windows as CDC Serial, open terminal (PuTTY) and…
    • Answered

  • Memory mapping code, and constants from certain files to ddr memory

    Resolved
    Other Parts Discussed in Thread: TEST2 , SYSBIOS Hi, Is it possible to configure the .cfg file to put all defines, constants, and executable code from certain files into external memory but keep other files constants and code in internal memory? Also…
    • Resolved
    • Answered

  • EDMACC0 in CCS emulator window

    Resolved
    Other Parts Discussed in Thread: OMAPL138 Dear E2E: I just installed (today) CCS 5.4. I found that "view registers' has EDMACC0ARM missing. I had similar problem with CCS 4.2. There was setup for EDMACC0ARM not done. Looks like the same problem…
    • Resolved
    • Answered

  • Question about using ARM in OMAP

    Resolved
    Hello. I'm trying to start ARM on OMAP. I just for starter want to start program which do nothing ( or even better: wake DSP ) I do not want to install Linux kernel. . I want my eXperimenter Kit from LogicPD to run autonomously without connection to CCS…
    • Resolved
    • Answered

  • BIOSUSB HID and Feature Report

    Resolved
    Other Parts Discussed in Thread: OMAP-L137 The BIOSUSB HID Keyboard example illustrates how to handle Input and Output report item. I need to send a Feature report item from Device to Host. I cannot see any place in the Jungo HID API that allows the report…
    • Resolved

  • AM1802 SPI boot problem

    Other Parts Discussed in Thread: AM1802 Hi, I have a AM1802 target board using SPI1 FLASH boot. I have set the boot mode pins as SPI1 FLASH mode, and the board was used to be booted successfully. Then I measured the SPI pins, OSCIN, OSCOUT, and boot…

Didn't find what you are looking for? Post a new question.