Part Number: ONET1130EP Other Parts Discussed in Thread: LMH13000 Tool/software: Hi,
I'm looking for the Continuous wavelength (CW) mode laser driver.
Does this part support CW mode (without any modulation)?
Regards,
Nanjunda M
Part Number: ONET1130EP Dear e2e support,
Could you confirm if the ONET1130EP part could be used in DML application (vs EML as mentioned in the datasheet)?
What would be the limitation?
Regards,
Part Number: ONET1130EP If using the EC version and disabling the CDRs (to simulate the EP version), should I expect any differences in propagation delay of the part?
thanks.
Mark
Part Number: ONET1130EP Other Parts Discussed in Thread: ONET1101L Hi TI expert
I want to know if ONET1130EP can support DML Model.
Best regards,
Thomas
Part Number: ONET1130EP Hi,
We are an electronics development company and we are developing a product for a client to convert electrical signals into optical signals at a frequency of 5Gbps.
The signals to be transmitted are a personalized signal with…
Part Number: ONET1130EP Other Parts Discussed in Thread: ONET1130EC-EVM , We are working on our first EML TOSA based design for a 10GbE CWDM transceiver. I’ve been eyeing up the ONET1130EP for interface with the optical components and am in need of a reference…
Hi Hugo,
Sorry for the delay in getting back. Here is my feedback on the question:
For low levels of incoming signals, the internal RX-LOS detection circuitry of the ONET1130EP is typically set to "low" range by setting RXLOSRNG (Bit 0 of Register 4)…
Part Number: ONET1130EP I am in the process of a project. I need convert USB3.0 signal to optical fiber data transfer and convert it back to USB3.0 at the device side. I try to evaluate it but I didn't find a demo board for this IC on TI website. Is there…
