WR,
WR KIM said: Did I make a mistake or miss anything?
Can you please provide a build log?
WR KIM said: After the building is finished, I can't find the file system in deploy-ti directory(~/tisdk/build/deploy-ti/images/am437x-evm).
What is the…
Part Number: PROCESSOR-SDK-AM437X Tool/software: Hi PROCESSOR-SDK-AM437X Support Team,
I haven't received a response to the last post in the following thread, so I'm reposting it. Can you help me?
RE: PROCESSOR-SDK-AM437X: Mitigating GPLv3 Compliance…
Part Number: PROCESSOR-SDK-AM437X Tool/software: Hi,
I haven't found any answers to the related questions (URL below), so I've started a new thread. Could you please check this internally so that we can respond?
https://e2e.ti.com/support/processors…
Hi Conor,
Conor said: TI's processor-sdk-linux-am437x contains many GPLv3 licensed components for the build host (development environment), and it seems very difficult to completely remove GPLv3 except for some parts.
Linux is an open source project…
Part Number: PROCESSOR-SDK-AM437X Other Parts Discussed in Thread: AM4372 Tool/software: SDK: ti-processor-sdk-linux-am437x-evm-09.03.05.02
linux:6.1.119
The configuration in my device requires the use of 6 serial ports. I have set uart0 to uart5…
Part Number: PROCESSOR-SDK-AM437X Tool/software: Hello Sitara fighters. I am developing a system using the SDK(*) on a custom board we developed. (*): PROCESSOR-SDK-LINUX-RT-AM437X(Version. 09.03.05.02)
When I checked with the Linux command "opencv_version…
Part Number: PROCESSOR-SDK-AM437X Tool/software:
Hi Team,
We are currently utilizing the ADC0 section of the AM437X in our project.
From ADC0, we are using both the 4-wire Touch Screen Controller (TSC) and four general-purpose ADC channels.
We…
Part Number: PROCESSOR-SDK-AM437X Tool/software: Hello ,
I 'm trying to run my kernel version on a custom board with am437x processor but i'm getting stuck in the "Starting kernel ..." message.we enable earlyprintk message and after that it shows below…
Part Number: PROCESSOR-SDK-AM437X Tool/software: Dear TI Support Team,
I am working with the AM437x Linux-RT SDK (version 09.03.05.02) and would like to configure DMTimer3 as a wakeup source to resume the system from standby (`echo standby > /sys/power…
user5926475 said: NAND: nand: error: insufficient OOB: require=106
The error is most likely due to the incorrect BCH scheme vs OOB size I spotted one error from your reply yesterday. >>>> #define CONFIG_NAND_OMAP_ECCSCHEME OMAP_ECC_BCH16_CODE_HW <<…
