Part Number: REG104 Hi Team,
I need to verify the Load and Line transient response of the part REG104 3.3V.
In datasheet, they given spec as below
as I have seen, the load transient has spec of around 500mV overshoot and 650mV undershoot for…
Part Number: REG104 Other Parts Discussed in Thread: TL1963A Tool/software: Hi,
I have a question for the Reg104: Can this part sink current as well? What would be the worst-case maximum current it can sink?
Due to a short, the regulator output likely…
Part Number: REG104 Other Parts Discussed in Thread: REG103
Hi,
Past week the series REG104 & REG103 was active.
Found out today the part number REG104FA-5/500G3 & REG103GA-3.3 or series REG104 & REG103 is coming to end of life.
Can you please…
Part Number: REG104 1.REG104GA-5/2K5
2.Huafeng measurement and control: voltage adjustment period test system
3.It has nothing to do with the schematic diagram. The customer has not been on the computer yet and PCB has not been involved, but the electrical…
Part Number: REG104 Other Parts Discussed in Thread: TPS7A47
Linear Voltage Regulator IC Positivie Adjustable 1 Output, SOT-223-6
I am reviewing a older control circuit. This circuit using the adjustable REG104GA-A. The R1 / R2 resistors have been…
Part Number: REG104 I'm looking at the REG104GA-3.3. It's both adjustable and set at 3.3V? What am I missing here?
Does this mean if I short R1 and leave R2 open, the regulator will output 3.3V?
Or is this product simply the most efficient at…
Other Parts Discussed in Thread: REG104 Question/Problem:
Is there any pulldown on the output when the REG104 is disabled?
Answer:
The only pulldown on the output is the feedback resistors and the external load.
Other Parts Discussed in Thread: REG104 I am using the REG104-A to power a small incandescent lamp (2.9V @ 700mA). Because a cold lamp filament presents a very low resistance, the current surge as the lamp turns on can be rather high. The REG104 will…
Other Parts Discussed in Thread: REG104 Question/Problem:
If the input of the REG104 is shorted to GND, will the output feed current back to the input?
Answer:
Yes, current will feedback through the body diode of the pass FET.
Part Number: SN75LVCP600S Other Parts Discussed in Thread: REG104 , DS64BR111 SN75LVCP600S datasheet recommends the part to be used one part used on the device-end daughter card (at Rx pins), and one part used on the host’s Rx pins. But in our application…
