Hi Jasper,
I'd recommend following the answers in the below threads for more information:
https://e2e.ti.com/support/sensors-group/sensors/f/sensors-forum/1042060/iwr6843aop-mmwave-radar-chip-and-board-selection-for-water-spray-quality-detection …
Hi Lee,
I am still waiting to see if there is a value I can share but I did get an estimate from our backend team stating that Max VBR and Vclamp will not vary much across operating temperature range, less than 0.5V delta. As I mentioned, this is one…
We are implementing runtime frequency switching in proprietary mode using RF_cmdFs for both TX and RX . The application dynamically switches frequency across the 430 MHz boundary , using different RF setup configurations for frequencies above and below…
Hello Jaehoon, 1. For range estimation, the Hardware Accelerator (HWA) present on board does FFT Computation. The "DPC_ObjDetRangeHwa_preStartConfig()" function which further calls "DPU_RangeProcHWA_config()" configures the paramsets for fast computation…
Part Number: AFE7900 Other Parts Discussed in Thread: AFE7950 I am looking for a RF transceiver for a space application. The AFE7900 meets our needs, but I see that only the AFE7950 is space qualified. The RF frequency range of the AFE7950 goes down to…
Hey Sekou,
PSRR is a function of the headroom between VIN and VOUT, so we can leverage existing PSRR measurements as long as the headroom conditions are matched. Based on your conditions, the headroom falls in the range of 1.5V to 2V, which means…
Part Number: ADS8688 Hi,
We are planning to implement Multilevel thersholding using ADC, whereas my input will be in DC voltage from the rf detector, so will my ADC accept DC voltage and provide the sampling data?
RF detector (Vout of Rf detector…
Part Number: ADS1255 Other Parts Discussed in Thread: TINA-TI I'm looking to get a sanity check on my understanding of the noise within my ADS1255 Signal Chain. The chain looks like the following
Loadcell -> 1st Order LP AAF -> ADS1255 -> MCU DSP Filter…