Part Number: SK-AM62-SIP Hello Team,
Am currently working on Buildroot linux system for my SK-AM62-SIP-EVM.
I donot see any buildroot linux bin/img or defconfig for the same.
Any sources for board specific img if available?.
If not guide me…
Part Number: SK-AM62-LP Other Parts Discussed in Thread: TPS65219 I'm attempting first boot on a new SK-AM62-LP (PCB rev PROC124E1) and the AM62 SoC never executes. The chip stays at ambient temperature regardless of boot configuration or power source…
Part Number: SK-AM62-LP Other Parts Discussed in Thread: AM620-Q1 Hi, is this EVM Board SK-AM62-LP in Active state or Obsolete..? i am able to see obsolete state in supplier Digi-key & mouser.
we want to purchase this evaluation board for our validation…
Part Number: SK-AM62-LP Hi Team,
We are using the SK-AM62-LP for development. We have a requirement to measure a frequency range of 1 Hz to 3 kHz on both the MCU and MPU (Linux) sides.
Could you please suggest the appropriate method and recommended…
Hello Gopal Sharma
Thank you for the query.
gopal sharma said: What is the purpose of current monitoring in the SK-AM62-LP using the INA231AIYFDR? Is it intended only for monitoring and information, or is it utilized by the BSP for SoC protection…
should i try it with built in firmware of root system or migrate it with help of below steps?
Umang Gajjar said: To enable BLE over SDIO, I:
Migrated drivers and libraries from the cc33xx-linux-mpu-ports GitHub repository. Follows Migration Guide…
Hello Gopal,
gopal sharma said: We have try to disabled Ethernet on the SK-AM62-LP kit through configuration; however, after doing so, the system starts crashing during kernel boot.
May I ask what steps you are currently using to disable Ethernet…
Part Number: SK-AM62-LP Hi Team,
We are using the SK-AM62-LP platform and are working on reducing the Linux kernel initialization time and userspace boot time.
We are referring to an E2E forum thread that is originally for AM62A: https://e2e.ti.com…
Part Number: SK-AM62 Hello,
While reviewing the WL18x7MOD WiLink RF layout on the SK-AM62 board, I noticed that the Wi-Fi/BLE antenna trace does not achieve 50 Ohm impedance when referenced to Layer 2 , but it does match 50 Ohm when referenced to Layer…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62 Hello, we have design a custom hardwared based on the SK-AM62 and we used the same DDR4 chip 'MT40A1G16KD-062E IT:E' but this is now obsolete.
Have you found a working alternative that we…
