Part Number: SK-TDA4VM Hello TI Community, Can I debug the SK-TDA4VM with the SDS560V2 at https://www.tms320f28x.co.kr/goods/goods_view.php?goodsNo=200903114&srsltid=AU7gw4WzzICImOdR0V2zr2XObxSGS5amyjPZVgAQa33Ky1-BOGdXIbPC Best Regards, Eric.
Hello,
Gautham Angadi said: Kindly assist the following questions 1) In section 3.7.2 for For updating MCU (DM) R5F firmware binary the command shared is below
host# cp <path_to_new_fw_binary>/vx_app_rtos_linux_mcu2_1.out <path_to_linux_installer…
Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: SK-TDA4VM , TDA4VM Hi,
We purchased an SK-TDA4VM evaluation kit about a year ago. Unfortunately, the SoC appears to have developed a short circuit during use. Our hardware team has confirmed that…
Hi Chandru,
mungara chandu said: Does the ONNX Runtime TIDL Execution Provider create and use its own OpenVX context internally?
I dont think so. Context should explicitly be created in the application.
Btw, are there any memory map changes? Does…
Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: SK-TDA4VM Hi,
I have SK-TDA4VM board, kernel 6.12.17-ti.
eth0 stays NO-CARRIER and never gets a DHCP lease. Already ruled out:
Cable/laptop port — confirmed good; laptop briefly showed "Connected…
Part Number: SK-TDA4VM Other Parts Discussed in Thread: TDA4VM , We have already received the QNX® SDP 8.0 BSP for Texas Instruments Jacinto 7 TDA4VM Starter Kit.
But SDK for this board shall be provided by TI.
QNX BSP manual for SK-TDA4VM starter…
Part Number: PROCESSOR-SDK-LINUX-SK-TDA4VM Other Parts Discussed in Thread: SK-TDA4VM I am evaluating SDE with GStreamer using the SK-TDA4VM evaluation board and PROCESSOR-SDK-LINUX-SK-TDA4VM (10.01.00.04).
I am encountering the issue described here…
Hello,
Thank you for your clarification. I have a few questions regarding the support for the SK-TDA4VM. You mentioned that RTOS drivers are not officially supported on the SK board and that only Linux is supported . Could you please help me understand…
Part Number: TDA4VM
My SK-TDA4VM board was booting normally from SD card until yesterday. Since today, it shows no output at all on the UART console. I don’t see the ROM boot messages, SPL/U-Boot, or kernel logs.
What I’ve checked so far:
SD boot…
Hello Neha,
neha gupta said: We narrowed Region 9 from 16MB down to 2MB (0xA7000000, matching your SDK's own "ring buffer" convention size used for the other cores). With just this 2MB, CPU1 booted fine. But under burst load, the original freeze came…
